Product Description; Use And Operation; Normal Operation; Specific Operation - SOMFY ROLLIXO RTS Manual De Uso

Rollixo RTS

3 - ProDuCt DesCriPtion

The ROLLIXO receiver, linked to a Somfy RDO CSI motor and a Somfy safety
edge solution, is designed to drive a vertically opening roller garage door.

4 - use anD oPeration

4.1 normal operation

> operation with a 2 or 4-button remote control
Press the programmed button to operate the door.
STOP
> obstacle detection operation
During closing, the detection of an obstacle causes the door to stop and re-
open partially.
The receiver warning light flashes rapidly to indicate that the door has
encountered an obstacle.
To return to normal operating mode, a command must be sent.
> integrated lighting operation
The lighting comes on each time the motor is switched on. It goes out
automatically 2 minutes after the door has stopped moving.

4.2 Specific operation

Depending on the additional accessories installed and the operating options
programmed by your installer, the system may have the following specific
functions:
> operation with a 3-button remote control
> operation with orange flashing light
The orange light flashes each time the motorisation is switched on, with or
without a 2-second warning depending on the configured parameter setting. It
stops flashing when the door stops.
> operation with cells
An obstacle placed between the cells will prevent the door from closing.
If an obstacle is detected while the door is closing, it stops, then re-opens fully.
The receiver warning light flashes rapidly until the obstacle is removed.
> operation with the alarm
The alarm is triggered for 2 minutes if the door is raised manually. No movement
of the door is possible when the alarm is sounding.
When the alarm sounds, press a button on a remote control memorised in the
receiver to stop it. The alarm can only be stopped with a memorised remote
control.
> operation in automatic closing mode
Automatic closure of the door occurs after a time delay programmed during
installation.
A new command during this time delay cancels automatic closing and the door
remains open.
The following command results in the closure of the door.
Copyright © 2014 Somfy SAS. All rights reserved.
STOP
STOP
STOP

4.3 adding remote controls

This operation must be carried out close to the receiver.
This operation involves adding a remote control to your installation by copying
a remote control already used on your installation.
Remote control "A" = "source" remote control already memorised
Remote control "B" = "target" remote control to be added
> 2 or 4-button remote control
A
[1]. Press the outer left and right buttons on the previously memorised remote
control simultaneously until the green indicator light flashes.
[2]. Press the remote control button A which controls your roller garage door
for two seconds.
[3]. Press the button on new remote control B which will control your roller
garage door.
> 3-button remote control
A
2s

5 - oPeratinG DiaGnostiCs

The indicator lights on the front of the Rollixo receiver notify the user of the
installation's status.
safety edge
fall protection
motor
1
STOP
indicator light status meaning
Off Functional installation
Rapid flashing Deactivation/activation in progress
Permanently lit Installation fault/failure
Diagnostics motor
Consequences
Actions
A
B
2s
B
< 1s
safety edge
transmitter batteries
Photoelectric
cells
2 3 4
Prog
indicator light status
Activated motor thermal protection
No movement possible
Wait around 10 minutes.
Prog
3