Kohler K-682 Guia De Instalacion página 4

30-7/8"
(784 mm)
3-3/16"
(81 mm)
2"
(51 mm)
Roughing-In
Before You Begin
NOTICE: Do not install the valve or power supply under a whirlpool surround or any location where the
temperature may exceed 104°F (40°C). The power supply and valve are rated to operate in temperatures
up to 104°F (40°C).
NOTICE: Do not apply excessive heat near the valve or apply flux or acids directly onto the valve. This
valve contains plastic and rubber components which will melt if heat is directly applied.
NOTICE: Do not apply petroleum-based lubricants to the valve components. Doing so will damage the
valve components.
NOTICE: Do not use oil-based, non-setting compounds, such as plumbers putty, on the threaded inlet
and outlet connections. Use sealant tape or liquid sealant.
NOTICE: Do not allow any outlet to flow more than 10 gal/min (37.9 l/min).
Read these instructions and determine the locations of all required components before beginning
installation.
When possible, install the valve before installing the other components.
If possible, flush all piping thoroughly before installing the valve. If the pipes are flushed after the
valve is installed, clean the inlet screens before using the system.
A qualified electrician should install a 120 V electrical outlet, within the stud framing, in close
proximity to the valve. A GFCI outlet may be required in certain applications.
If possible, install the electrical outlet prior to installing the valve.
1043183-2-E
13' - 1/8"
(3968 mm)
5-15/16"
(151 mm)
Cold
3/4" NPT Inlets
2-3/16" (56 mm)
3-1/16" (78 mm)
1-5/16" (33 mm)
21-5/16" (541 mm)
20-1/8" (511 mm)
Hot
1-3/4" (44 mm)
1-3/4" (44 mm)
1-3/4" (44 mm)
1-3/4" (44 mm)
1-3/4" (44 mm)
22-1/4" (565 mm)
4
7-3/8"
3"
(187 mm)
(76 mm)
9-3/16"
(233 mm)
1/2" NPT Outlets (6)
3-5/16"
2-1/8"
(84 mm)
(54 mm)
Kohler Co.