Ritmo ELEKTRA LIGHT Manual De Instrucciones Y Mantenimiento página 32

MENÙ 3/8 (MANUAL TYPING OF VOLTAGE AND WELDING TIME)
INPUT VOLTAGE/TIME
40.0V
160s
HAVE YOU SCRAPED AND ALIGNED?
WELDING... 40.0V
WELDING CORRECT!
6
Usually raised, printed in a label attached to the coupler, or indicated on a badge/card supplied with the
coupler.
EN
32
Note:
requires the knowledge of the
voltage/time
suggested
manufacturer
beginning of welding. If, for
whichever
information
please
manufacturer before starting to
weld.
Press OK to access the manual
mode (in which you will be
required to enter voltage and
time).
The last voltage value set in will
be displayed.
Press B (Increase/Decrease) to
set the correct voltage. Press OK
to confirm.
The last time value set in will be
displayed.
Press B (Increase/Decrease) to
set the correct time. Press OK to
confirm.
Most Important!
Before-welding
(scraping
compulsory to obtain a good
welding. Don't press OK until you
have
operations. Once you press OK
160s
you will assume all responsibilities.
Attention please! You can stop
the welding at any time by
pressing STOP but you must
absolutely contact the coupler
manufacturer to know if the
coupler may still be welded once
cooled off.
The
welding cycle is confirmed by the
message "WELDING CORRECT!"
on the display.
Press STOP to return to the main
menu.
This operating
parameters
by the coupler
, prior to
6
reason,
is not available,
contact the coupler
operations
and cleaning)
performed
good outcome of
mode
the
that
are
these
the