Ritmo ELEKTRA LIGHT Manual De Instrucciones Y Mantenimiento página 30

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

OPERATING INSTRUCTIONS WITH BARCODE READER
MENÙ 1/8 (BAR CODE READING WITH BARCODE READER)
READ BAR CODE
I CPL xxx 32mm 40.0V 160s
HAVE YOU SCRAPED AND ALIGNED?
WELDING... 40.0V
WELDING CORRECT!
EN
30
Keep the trigger pressed and
make sure the laser beam aims at
the
Information about the coupler
manufacturer
Important: in case of malfunction
of the laser scanner, it is possible
to work in manual mode (see
page 36)
Press OK to start welding.
The
information
coupler
diameter, welding voltage and
time. If the information is correct
press OK to confirm; otherwise,
repeat the bar code reading as
explained above.
Important!
Before-welding
(scraping
compulsory to obtain a good
welding. Don't press OK until you
have
operations. Once you press OK
you will assume all responsibilities.
Attention please! You can stop
the welding at any time by
pressing STOP but you must
160s
absolutely contact the coupler
manufacturer to know if the
coupler may still be welded once
cooled off.
The
welding cycle is confirmed by the
message "WELDING CORRECT!"
on the display.
Press STOP to return to the main
menu.
welding
bar
is
displayed.
display
will
show
regarding
manufacturer
operations
and
cleaning)
performed
good
outcome
of
code.
the
the
and
are
these
the
Tabla de contenido
loading

Tabla de contenido