Ritmo ELEKTRA LIGHT Manual De Instrucciones Y Mantenimiento página 25

DO NOT OVERWORK THE EQUIPMENT. Respect the performance limits given by the
➢
manufacturer in order to guarantee the equipment a good quality service life at the
best safety conditions.
USE PROPER EQUIPMENT
➢
recommended accessories - pay particular attention to generator sets, power supply
cables, extensions, pin cables, pins. Electrical tools must cool off before being used
again, specially after long working cycles. The use of accessories and/or tools not
compatible and/or not recommended by the manufacturer may cause harm to the
operator, compromise the working of the machine and/or other tools, besides
invalidating the machine warranty.
DO NOT USE THE CABLES IMPROPERLY. Do not pull the cables to transport the machine
➢
or to unplug it. Protect the cables from heat and cutting edges.
USE THE ALIGNERS. Always lock the pipes/fittings/couplers with the proper aligner
➢
before start welding; besides assuring the conditions necessary to a good quality
welding, it also prevents possible harm to the operator.
ATTENTION PLEASE! BE SURE TO AVOID ACCIDENTAL START-UP OF MACHINE AND/OR
➢
ANY OTHER ELECTRICAL DEVICE. When turning on the generator, be sure that the
machine is not plugged to it. Wait until the generator has stabilized to plug the
machine - the generator may create spurious voltages during ignition, which would
cause irreparable damage to the printed circuit board and other electronic
components of the machine. Keep the machine disconnected from the power source
during insertion of pins. Before connecting the machine to the power source, be sure
the machine ON/OFF switch is OFF - this is of utmost importance specially when using
a device without a safety microswitch. Never move a device from one place to
another when it is still connected to the power source; it could accidentally turn itself
on.
BE SURE THE MACHINE IS NOT DAMAGED BEFORE START USING IT. Before starting to weld,
➢
be sure that all safety devices are working perfectly. Be sure the cables (power source
and welding ones) are intact and devoid of cuts or abrasions. Be sure the pins and the
terminals connect perfectly and that their surface contacts are clean. Be sure that the
machine hasn't suffered any incidental impacts that may have irreparably damaged
the chassis (which could cause water infiltration).
ANY REPAIRS AND/OR OVERHAULS TO THE MACHINE AND/OR ITS ACCESSORIES ARE TO
➢
BE DONE EXCLUSIVELY BY THE MANUFACTURER OR BY A SERVICE CENTER AUTHORIZED
BY THE MANUFACTURER. The machine indicated in this handbook respects the safety
regulations in force; any and all intervention to the machine done by a non authorized
service center will automatically invalidate any warranty claims and any liability on
the part of the machine manufacturer.
NEVER MODIFY THE MACHINE.
➢
USERS MUST BE QUALIFIED AND DULY TRAINED. Only qualified and trained personnel
➢
shall be allowed to use the machine indicated in this handbook as well as any and all
working equipment.
USE ONLY NEW OR OVERHAULED EQUIPMENT. Remember that the machine indicated
➢
in this handbook must be maintained and overhauled exclusively by an authorized
service center.
DO NOT USE THE MACHINE IN ATMOSPHERES SUBJECT TO EXPLOSION FOR THE PRESENCE
➢
OF INFLAMMABLE VAPORS, GAZES, ETC.
RESPECT THE APPLICABLE LOCAL/NATIONAL/INTERNATIONAL HEALTH AND SAFETY LAWS,
REGULATIONS, STANDARDS AND REQUIREMENTS, AT ALL TIMES.
AND ACCESSORIES. Use only compatible and/or
EN
25