Ritmo ELEKTRA LIGHT Manual De Instrucciones Y Mantenimiento página 31

MENÙ 2/8 (MANUAL TYPING OF BAR CODE)
INPUT BAR-CODE
3 7 1 0 4 9 2 3 9 _ _ _ _ _ _ _ _ _ _
_ _ _ _
I CPL xxx 32mm 40.0V 160s
HAVE YOU SCRAPED AND ALIGNED?
WELDING... 40.0V
WELDING CORRECT!
Press OK to access the manual
insertion
characters.
Read
underneath the bar code and
type
(Increase/Decrease)
pushbuttons. Press OK to confirm
each value typed. Proceed like
this for all the 24 characters. To
cancel the last number press
STOP.
As soon as all the characters are
inserted,
welding.
The
information
coupler
diameter, welding voltage and
time. If the information is correct
press OK to confirm; otherwise,
repeat the insertion of the bar
code as explained above.
Most Important!
Before-welding
(scraping
compulsory to obtain a good
welding. Don't press OK until you
have
operations. Once you press OK
you will assume all responsibilities.
160s
Attention please! You can stop
the welding at any time by
pressing STOP but you must
absolutely contact the coupler
manufacturer to know if the
coupler may still be welded once
cooled off.
The
welding cycle is confirmed by the
message "WELDING CORRECT!"
on the display.
Press STOP to return to the main
menu.
of the bar
the 24 characters
them using the
press OK to
display will show
regarding
manufacturer
operations
and cleaning)
performed
good outcome of
code
B
start
the
the
and
are
these
the
EN
31