Dometic TEC40D Instrucciones De Uso página 17

TEC40D
Display message
Description
OIL TEMP PRESS
Insufficient engine oil.
Engine temperature too high.
GENERATOR ALERT!
General alarm message
OVERLOAD!
The consumers generate an
overload at the output.
SHORT CIRCUIT
The consumers cause a short
circuit at the output.
OVER TEMPERATURE
The inverter temperature is too
high.
LOW POWER ENGINE
The inverter supply voltage has
dropped.
GEN CAL
A message appears when the
generator is started up; it shows
the calibration phase which
takes place before each start-up.
The generator does not supply
any voltage.
GEN WAIT
A message appears while you
are waiting for the generator to
start again.
EN
Generator behaviour
The generator stops.
The generator stops.
The inverter switches off, there-
fore no voltage is supplied but
the engine carries on running
until it goes off.
The inverter switches off, there-
fore no voltage is supplied but
the engine carries on running
until it goes off.
The inverter switches off, there-
fore no voltage is supplied to
cool the generator, but the
engine carries on running.
The generator stops.
The generator is running but
does not supply any voltage.
The generator is switched off.
Operating the generator
Measures
Fill up with oil (see chapter
"Checking the oil level" on
page 18).
Leave the generator to cool
down for a few minutes then start
up the generator again.
Check the system by referring to
the troubleshooting table.
If the problem persists, contact
the manufacturer's branch office
in your country (addresses on the
back page).
Reduce the connected load and
start the generator again.
Check the connected consum-
ers then start the generator
again.
Leave the generator to cool
down for a few minutes then start
up the generator again.
Reduce the connected load and
start the generator again.
Wait a moment.
Wait until the message has disap-
peared then attempt ignition
again.
17