Before Use - Panasonic MJ-L600 Instrucciones De Funcionamiento

Before Use

-Disassembly and Assembly of the parts-
Disassembly / Assembly of attachments
●
The following steps show how to disassemble / assemble attachments, using the juice attachment as an
example.
Disassembly
1
Remove
the juicing
bowl from
the motor
housing.
2
Remove the juice /
smoothie attachment or
frozen cone.
●
Squeezing screw comes out with it.
Squeezing screw
Frozen cone
3
Separate the parts.
Juice cone or
Smoothie cone
Frozen cone
Rotating brush
GB12
1
Make sure the gasket, rubber
plug and rubber brushes are
in place correctly.
●
Gasket is located in the juicing bowl.
Top view
●
Rubber plug is located outer bottom.
Push it in until
no gap.
Outer bottom view
●
Rubber brushes are located on side of the
rotating brush.
See page GB20 for how to install the gasket,
rubber plug and rubber brushes.
●
The juicer may not work properly if they
are not assembled correctly.
Assembly
2
Set the juicing bowl on the motor
housing.

Align the " " mark on the motor housing and the

" " on the juicing bowl.
3
Attach the rotating brush and juice cone / smoothie cone
or frozen cone, then set it on the motor housing.

Align the " " mark on the motor housing and the

" " mark on the juice / smoothie attachment.
Top view
4
Mount the squeezing screw.
Insert the squeezing screw into the centre.
1
Rotate the squeezing screw and push it into the
2
hole until it stops.
● The lid cannot be closed if the squeezing screw is
not pushed down sufficiently.
● Be careful not to get your finger clamped in the
gap between the squeezing screw and the juice
cone / smoothie cone.
Frozen cone
① ●
② ●
GB13