Service Codes
During operation, the display may show the follow-
ing service codes:
PCE1
PCE5
PCE6
HOT
Important
Contact an authorized servicer if the display shows any
code except "HOT", "HI", and "LO". Service must be
performed before using oven.
• If display shows "HOT", oven's magnetron is
overheated. Oven automatically interrupts
cooking sequence and turns on cooling fan until
normal temperature is reached. When magnetron
cools to normal temperature, oven resumes
operation.
• If display shows "HI" or "LO", input voltage is too
high or too low. Because cooking results will not
be representative of normal cooking pattern, oven
is not usable during this condition. When voltage
returns to normal range, oven resumes operation.
S1
CS
FL
FH
PL
HI
LO
Ordering/Service Information
An authorized servicer must inspect equipment
annually. Record all inspections and repairs for future
reference.
Any questions or to locate an authorized servicer, call
equipment supplier. When contacting supplier, provide
product information including model, manufacturing and
serial numbers and date of purchase. Model manufac-
turing and serial numbers are located on product
nameplate. Warranty service must be performed by an
authorized servicer. Amana also recommends
contacting an authorized servicer if service is required
after warranty expires.
Be sure you have read and followed all instructions.
Avoid unnecessary service calls for difficulties that are
not the result of defective workmanship or materials.
You will be charged for a servicer's travel expenses and
labor, even though the product may be in warranty, if the
difficulty is not caused by workmanship or materials, or if
that component is considered customer-replaceable.
Your oven should never be operated without a food load
or without the oven floor in position. If for any reason the
oven floor becomes broken, DO NOT OPERATE THE
OVEN UNTIL THE OVEN FLOOR HAS BEEN
REPLACED AND SEALED IN POSITION.
13