Earthing Instructions; Installation; External Equipotential Earthing Terminal; Unpacking Equipment - Amana MC52200 Serie Manual Del Propietário

Earthing Instructions

To avoid the risk of electrical shock or death, this
equipment must be earthed.
To avoid the risk of electrical shock or death, do not
alter the plug.
This equipment MUST be earthed. In the event of an
electrical short circuit, earthing reduces the risk of
electric shock by providing an escape wire for the
electric current. This oven is equipped with a cord
having a earthing wire with a earthing plug. The plug
must be plugged into an outlet that is properly installed
and earthed.
Consult a qualified electrician or servicer if earthing
instructions are not completely understood, or if doubt
exists as to whether the equipment is properly earthed.
Do not use an extension cord. If the product power cord
is too short, have a qualified electrician install a three-
slot receptacle. This oven should be plugged into a
separate 50 hertz circuit with the electrical rating as
shown in the appropriate drawing. Model requires a 230
supply voltage. When a microwave oven is on a circuit
with other equipment, an increase in cooking times may
be required and fuses can be blown.
230V–32AMP
Warning
Warning

Installation

External Equipotential Earthing Terminal

Equipment has secondary earthing terminal. Terminal
provides external earthing connection used in addition
to earthing prong on plug. Located on outside of oven
back, terminal is marked with symbol shown below.

Unpacking Equipment

• Inspect equipment for damage such as dents in door
or dents inside oven cavity.
• Report any dents or breakage to source of purchase
immediately. Do not attempt to use oven if damaged.
• Remove all materials from oven interior.
• If oven has been stored in extremely cold area, wait a
few hours before connecting power.

Equipment Placement

• Allow at least 1.5 inches/3.81 centimeters of
clearance around top and sides of equipment. Proper
air flow around equipment cools electrical
components. With restricted air flow, oven may not
operate properly and life of electrical parts is
reduced.
• Allow at least 2 9 / inches / 6.5 centimeters between
16
air discharge on back of equipment and back wall.
• Do not install equipment next to or above source of
heat, such as pizza oven or deep fat fryer. This could
cause microwave oven to operate improperly and
could shorten life of electrical parts.
• Do not block or obstruct oven filter.
• Allow access for cleaning.

Radio Interference

Microwave operation may cause interference to radio,
television, or similar equipment. Reduce or eliminate
interference by doing the following:
• Clean door and sealing surfaces of oven according to
instructions in "Care and Cleaning" section.
• Place radio, television, etc. as far as possible
from oven.
• Use a properly installed antenna on radio, television,
etc. to obtain stronger signal reception.
5