Operating Notes; Do Not Operate The Unit When Empty; Do Not Put Excessive Weight On The Door; Set-Up And Close Procedures - Amana MC52200 Serie Manual Del Propietário

Operating Notes

If door is opened during heating process, Q-ing energy
ceases. Blower continues to operate. Close door and
press START to continue oven operation and
countdown timing.
If RESET is pressed once while oven is operating,
Q-ing energy ceases, but countdown time remains in
display. Press START to continue oven operation and
countdown timing. If RESET is pressed twice, oven
stops and current program cancels.
When unit is plugged in or repowered after the loss of
electricity, it will take several seconds before dashes
and menu indicator display. Once displayed, unit is operational.

Do Not Operate the Unit When Empty

When operating oven, be sure there is absorbing
material (food, water) inside oven. Insufficient or
improper food loads or improper containers (metal)
may cause magnetron to overheat. When this happens,
thermal switch will eventually turn oven off to allow
magnetron to cool. Several minutes will elapse before
switch resets and allows oven to operate.

Do Not Put Excessive Weight on the Door

Door is not designed to hold excessive weight which
might cause door to become misaligned, resulting in
improper operation.
To avoid electrical shock which can cause severe
personal injury or death, do not remove outer case at
any time. Only authorized servicer should remove
outer case.
Warning

Set-Up and Close Procedures

Open

1. Verify all units are plugged into proper outlets.
2. Open and close door to unit. Blower fan will start
and control panel will display active menu item.
Press BREAKFAST-1 pad for breakfast category.

Transition

At transition, be certain to change menu category by
pressing menu pad. Units will remain in this category
until changed at close.

Close

1. With clean, sanitized towel dipped in McD
Sanitizer (HCS), thoroughly wipe inside walls, floor,
door and splatter shield at top of oven. Be sure to
"wring" sponge or cloth to remove excess water
before wiping unit. Water pressure type cleaning
systems should not be used to clean oven interior or
exterior. If splatter shield has areas that require
more cleaning, it can be removed following
procedure outlined on page
If stubborn splatters exist on walls, one cup of
tap water can be boiled in oven for 1-2 minutes. Use
your Amana wattage beaker for this procedure.
Steam from boiling water will help loosen splatters.
Do not use abrasive cleaners or cleaners containing
ammonia. They might damage the finish. Never pour
water into the bottom of the oven.
Important
Clean air filter regularly to prevent overheating,
which may lead to oven damage.
2. Wipe exterior with clean, sanitized towel soaked
in MCD Sanitizer (HCS). Air dry.
3. Close door after cleaning, and press appropriate
menu pad for breakfast category. Unit is ready
for Open.
6
11.
Caution