Battery & Product Disposal Information; Checklist - miniland baby thermoadvanced plus Manual De Instrucciones

10.3. BATTERY & PRODUCT DISPOSAL INFORMATION
If your thermometer will not be used on a regular basis, remove the
battery to prevent possible damage due to chemical leakage. If battery
does leak, removecarefully. Do not allow bare skin to come in contact
with the leaking fluid.
Used batteries should be removed.
Remember to dispose of the product responsibly.
Don't throw battery into a fire, the battery is likely to explode.
Do not mix products bearing the crossed out bin symbol with your general
household waste.
For the correct collection and treatment of these products take them to the
collection points designated by your local authority. Alternatively contact the
retailer who sold you the product.
10.4. INSTALLATION/REMOVAL OF BATTERIES
When the low battery indicator [
not function at all, you should replace the old batteries with new ones as soon as
possible. This product uses two AAA 1.5V batteries, use the following procedure
to replace or insert batteries:
1. Open the battery cover following the direction of the arrow.
2. Remove the old batteries and then insert the new batteries into the battery
compartment. Make sure you install the new batteries properly; be sure to match
the positive and negative ends of the battery to the marking in the batteries
compartment of the thermometer.
3. Replace the battery compartment cover and press to close.
11. TROUBLESHOOTING
PROBLEMS
No response/
Automatic reset
when pull out
insulator.
Battery symbol
on LCD.
Lo" on screen.
"Hi" on screen.
"ErrP" or "ErrH"
on screen.
] appears on the LCD, or the thermometer does

CHECKLIST

Battery used up.
Battery in wrong polarity.
Poor battery contact.
Low battery.
The measured temperature
is lower than 32.0ºC/89.6ºF.
Please check the operation
method.
The measured
temperature is higher than
42.9ºC/109.3ºF.
Please check the operation
method.
Hardware problem.
SOLUTIONS
Change new battery.
Remove battery, turn it over
and re-insert.
Remove battery, clean
contacts and re-insert.
Replace with new battery.
Follow the steps in the user
manual for proper reading.
Follow the steps in the user
manual for proper reading.
Contact the manufacturer or
distributor.