DeWalt DXV04T Manual De Instrucciones página 7

WARNING!
To reduce the risk of fire or explosion, do not operate this vac in
areas with flammable gases, vapors or explosive dust in the air.
Flammable gases or vapors include but are not limited to: lighter
fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol or
aerosol sprays. Explosive dusts include but are not limited to:
coal, magnesium, aluminum, and grain or gun powder. Do not
vacuum explosive dust, flammable or combustible liquids or hot
ashes. Do not use this vac as a sprayer for any flammable or
combustible liquid. To reduce the risk of health hazards from
vapors or dusts, do not vacuum toxic materials.
WARNING!
The operation of any utility vac can result in foreign objects being
blown into the eyes, which can result in severe eye injury.
Always wear safety goggles complying with ANSI Z87.1 (or in
Canada, CSA Z94.3) before starting operation.
CAUTION:
To reduce risk of hearing loss, wear ear protectors when using
the vac for extended hours or when using it in a noisy area.
The unit is ready for dry vacuuming or blowing. After you plug the
power cord into the wall receptacle, turn the unit "ON" by pushing
the switch position wit h 1 embossing straps is the "ON" position.
ON OFF ON OFF
7
DRY PICK-UP
1. The filter must always be in correct position to reduce the risk
of leaks and possible damage to vac. Make sure that the filter
is completely covering the filter cage. Make sure there are no
gaps between the filter and the lid. It is very important to
assemble the filter to the cage without allowing any possible
leaks or tears. Any leaks will allow the picked up debris to be
blown out of the blowing port and back into the surrounding
environment.
2. When using your vac to pick up very fine dust, it will be
necessary to empty the dust tank and clean or replace the filte r
at more frequent intervals to maintain peak vac performance.
NOTE
A dry filter is necessary to pick up dry material. If you use your
vac to pick up dust when the filter is wet, the filter will clog quickly
and be very difficult to clean. If the filter gets wet, replace it before
continuing to do dry pickups.
INSTALLING THE CARTRIDGE FILTER
The cartridge filter can be used for wet or dry pick, installation is
the same for both.
1. With the power head in an upside down position, slide the
cartridge filter down over the lid cage, push the filter seals
against the power head.
2. Turn the knob on filter retainer clockwise to tighten,
the filter into place.
3. To remove the filter for cleaning, turn the filter knob counter
clockwise till feel the tactile and auditory cue, and make sure
the knob arrow align with the "Unlock" icon on the filter cap,
then slide the cartridge filter off the lid cage. then grasp the
step of knob tightly with fingers to pull the cartridge filter out
off the cage.
locking