Setup Mode - Samson Graphite 49 Manual Del Propietário

Graphite 49 · USB/MIDI Keyboard Controller

Setup Mode

Setup mode enables you to make adjustments to how the Graphite 49 will operate. Pressing the
SETUP button will enter Setup Mode, the keyboard will stop transmitting MIDI data, and the first
17 keys will function as numerical pads.
Controllers
To adjust a controller, press a button, move a slider
or encoder, or press the pedal, and its name and
parameter values will appear on the display.
Press the PAGE ◀ / ▶ buttons to cycle through the
available parameters. The parameter name will be
displayed and the value will flash. Use the DATA
+/– buttons or numerical keys to set the appropri-
ate value.
Note: When the value Ch is set to "-", the controller
follows the keyboard channel in Zone 1. You can use
the DATA button to select "-", or press the 0 key on the
keyboard to select "-".
Press the ENTER button or the ENTER key on the
keyboard to confirm a selection. You can confirm
the selection after each parameter, or after you
finish editing all parameters for a controller. The
new values will be saved and updated on the
display.
Note: The slider and encoder settings are saved into the current activated bank. Press the BANK ◀ / ▶
to change the bank where the settings will be saved.
If you select another controller, or press the SETUP or MAIN buttons before saving your changes,
your changes will be lost. Simultaneously pressing the DATA + and DATA – buttons will restore the
controller to its original setting.
The setting of sliders, encoders and transport buttons cannot be changed in the Remote Control
Preset. The components assigned to the function buttons vary according to the software title you
are using.
A
B
A
B
17