Troubleshooting Table - IPC 1050 Serie Manual De Instrucciones

SECURITY CODE
MOTOR PAUSE
TRACTION PAUSE
BRUSH CURRENT
CHANGE THE OIL
BATTERY RESERVE
FLAT BATTERY
BATTERY WORN OUT
BRUSH WORN OUT
BRAKE
English (Translation of original instructions)

TROUBLESHOOTING TABLE

MACHINE BEHAVIOUR
THE TRACTION IS
BLOCKED
THE TRACTION IS
BLOCKED
THE OPERATING
FUNCTIONS STOP
THIS APPEARS ONLY IF
THE MACHINE IS FITTED
WITH AN ENDOTHERMIC
ENGINE
WARNING THAT THE
BATTERY IS ALMOST FLAT
THE MACHINE
FUNCTIONS ALL STOP
WITH THE EXCEPTION OF
THE TRACTION
THE MACHINE IS
BLOCKED
THE MACHINE
CONTINUES TO RUN
The parking brake is on
ERROR DESCRIPTION
TRACTION ENGINE
OVERHEATS TO 95°C OR THE
ALTERNATOR OVERHEATS TO
150°C
THE ELECTRONIC CONTROL
CIRCUIT OVERHEATS TO >
85°C
EXCESSIVE POWER DRAW OR
CENTRAL BRUSH LOCK
IT IS ACTIVATED ONLY AFTER
99 WORKING HOURS
THIS HAPPENS WHEN THE
BATTERY VOLTAGE FALLS
BELOW 21V
IF FOR 3 CONSECUTIVE
SECONDS THE VOLTAGE READ
BY THE KEY IS LESS THAN
20.3V
IF FOR 3 CONSECUTIVE
SECONDS THE VOLTAGE READ
BY THE KEY IS LESS THAN 18V
THE BRUSH NO LONGER
APPLIES SUITABLE PRESSURE
TO THE FLOOR AS IT IS WORN
OUT
- 27 -
POSSIBLE INTERVENTION
HAVING GONE UP A STEEP
SLOPE, THIS MAY BE NORMAL.
LEAVE THE ENGINE TO COOL
DOWN FOR 20 MINUTES.
CHECK THAT THE COOLING
FAN IS WORKING CORRECTLY.
CHECK THAT THE BRAKE IS
NOT BLOCKED.
CHECK THAT THE TRACTION
WHEEL SPINS FREELY.
IF THE ATMOSPHERIC
TEMPERATURE IS HIGH,
STOP THE MACHINE FOR 20
MINUTES AND THEN RESTART
IT. IF THE PROBLEM PERSISTS,
CALL THE SERVICE CENTRE
CHECK THE BRUSH RUNS
SMOOTHLY AND CHECK FOR
ANY IMPEDIMENTS (STRING,
NYLON OR OTHER)
ENGINE OIL REPLACEMENT
SIGNAL (TO RESET PRESS
THE DISPLAY BUTTON FOR 5
SECONDS ON THE OIL HOUR
COUNTER SCREEN)
NO INTERVENTION REQUIRED
OTHER THAN CHARGING THE
BATTERY
RECHARGE THE BATTERY
RECHARGE THE BATTERY
REPLACE THE CENTRAL
BRUSH
Release the parking brake