Adjusting The Brake - IPC 1050 Serie Manual De Instrucciones

Refit the cover of the brush compartment and tighten the
knobs by following the disassembly instructions in reverse
order.
MAINTENANCE, CHECKING AND RECHARGING THE
Check the level of electrolyte inside the batteries regularly.
The battery compartment is under the operator's seat. Raise
the bonnet and open the caps on the cells. If necessary, top up
with distilled water.
The level of electrolyte is indicated in the battery instruction
handbook.
IMPORTANT: check the battery level every 100 hours. After
you have filled the battery, close the cells with their caps and
clean the top surface.
Pay the utmost attention when you are handling the battery
liquid, as it is corrosive. In the event of contact with your skin
or eyes, wash with plenty of fresh water and seek medical
assistance.
Whenever necessary, charge the battery according to the
following instructions:
· Turn the machine off with the main key.
· Raise the bonnet.
· Disconnect the machine's battery connector.
English (Translation of original instructions)
BATTERY
The battery must be recharged in a sufficiently ventilated area
· Open up all the caps of the battery cells.
· Connect the battery connector to the battery charger.
Connect the battery charger to the mains (the mains voltage
and frequency ratings must correspond to those of the battery
charger).
After charging, disconnect the battery from the charger and
hook it up to the machine.
Put the caps back on and clean the top surface of the battery.

ADJUSTING THE BRAKE

If the service brake or parking brake is not effective enough, it
can be adjusted by acting on the front wheel. Loosen locknut B
by turning screw A and then tighten locknut B again
- 23 -