Emergency Situations; Troubleshooting - IPC 161 D Manual De Instrucciones

14. DISMANTLING / DEMOLITION
CAUTION: The dismantling or demolition must be executed by the customer in total observation of the laws in force on
subject, by delivering the whole machine or its components to companies specialized in these services.

15. EMERGENCY SITUATIONS

In any kind of emergency situation such as, for example, if you have accidentally driven the sweeper over current-carrying
cables on the floor which have wound around the central or side brush, or there are strange noises coming from inside the
machine or motor, or you have accidentally picked up incandescent materials or flammable liquids, chemical products in
general, poisons, etc.
PROCEED AS FOLLOWS:
1) Disconnect the drive by letting go of the lever.
2) Switch the motor off, by turning the starter key on the control panel anticlockwise.
3) Remove all the materials that have been collected by means of safety gloves and, if necassary, a mask to protect your
respiratory tracts.

16. TROUBLESHOOTING

Two main faults may occur with the 161 E-D power sweepers: the machine causes dust to rise during use or leaves dirt on the
floor. There can be many reasons for these, but if the machine is used correctly and routine maintenance is carried out regularly,
they cannot occur very often. Therefore:
DEFECTS
1) The machine causes dust.
2) The machine leaves traces of dirt on
the floor.
3) The battery-powered sweeper is not
performing correctly.
F
CAUSES
1) - Filter clogged.
- Filter damaged.
- Filter fitted badly.
- Rubber dust flaps damaged.
- You are constantly using the side
brush.
2) The central brush is incorrectly
adjusted or worn.
- You have collected wires, string,
etc..
- The side seals are damaged.
- Collection box full.
3) Battery flat or not fully charged.
- The battery charger is not the
recommended one.
D
REMEDIES
1) - Shake it with the filter-shaker and
if necessary take it out and clean it
thoroughly.
- Replace it.
- Fit it correctly in place and close the
hooks provided.
- Replace them.
- Use the side brush for edges, bor-
ders and corners.
2) Adjust the central brush checking its
"track".
- Remove them.
- Replace it/them.
- Empty it.
3) Check the level of the electrolyte and
carry out a new complete battery
charging cycle.
- Use an appropriate battery charger.
E
39