FALMEC DOWNDRAFT Manual De Instrucciones página 21

shut-down after 15 minutes. At the end of the 15' the motor and the light will
switch off and the mobile part will close. The red LED flashes to indicate that
the function is active. The countdown does not stop by varying the motor
speed. If the motor is stopped with key 2, the function will automatically deacti-
vate. When the timer function is active, it is possible to deactivate it by pressing
key 1.
Filter Reset: Every 30 hours of extractor fan operation, the filter signal will activate
(steady red light). With motor and light switched off and by applying prolonged
pressure on the T1 key, the signal will be annulled and the shutter will open to
access the filters. During this state it is not possible to activate the motor and
the T2.. T5 keys are inhibited. Once the filters have been repositioned, applying
prolonged pressure on the T1 key will close the shutter and the T2..T5 keys will
be enabled again.
Opening of mobile part: When all the LEDs are switched off (light and motor off), ap-
plying prolonged pressure on the key will enable to open the mobile part of
the range hood for maintenance operations. In this state it is not possible to
activate the motor, T2..T5 keys are inhibited. T1 key is enabled.
Closure of mobile part: To exit the state with mobile part open and motor off, apply
prolonged pressure on the T1 key. The red T1 signal will switch off and from
this moment the T2..T5 keys will be enabled again.
2: 1° (1ST) / OFF - RECIRCULATION FUNCTION
1° (1st) / OFF: If the motor is stopped or at a different speed from the 1° (1st), press-
ing the key will activate the 1° (1st) speed, and the T2 key will light up. If the
mobile part is closed, it will open, and the extractor fan will activate after a few
seconds. During opening of the mobile part, the T2..T5 key will be deactivated.
If the motor is at 1° (1st) speed, pressing the key will stop the extractor fan and
the T1 key will switch off. If the lights are turned off, the mobile part will be
closed.
Recirculation Function: When the motor is turned off, applying prolonger pressure on
the T2 key will activate the recirculation function, and the mobile part will open.
The T2 key will flash. During the recirculation function (24 hour duration), the
range hood will remain active for 1 hour at 1° (1st) speed, then it will stop for 3
hours and reactivate for another hour. These cycles are repeated until timeout.
With activation of this function, other speeds may not be selected. To deactivate
this function, keep the T2 key pressed for at least 3 seconds.
3: 2° (2ND) SPEED
If the motor is at a different speed from the 2° (2nd), pressing the key will acti-
vate the 2° (2nd) speed, and the T3 key will light up.
If the motor is stopped, the key is disabled.
4: 3° (3RD) SPEED
If the motor is at a different speed from the 3° (3rd), pressing the key will acti-
vate the 3° (3rd) speed, and the T4 key will light up.
If the motor is stopped, the key is disabled.
5: 4° (4TH) SPEED
If the motor is at a different speed from the 4° (4th), pressing the key will acti-
vate the 4° (4th) speed, and the T5 key will light up.
If the motor is stopped, the key is disabled.
19