FALMEC DOWNDRAFT EVO Manual De Instrucciones página 25

Non-prolonged pressure = finger pressed on key for less than 3 seconds, the function activates upon
its release.
Radio control (optional): Place the device far from sources of electromagnetic waves which could
interfere with the range hood's electronic functions
Maximum operating distance 4 metres. This distance may vary in defect based on electro-
magnetic interference of other devices.
Function of the
remote control
Light Key
' - ' Key
' + ' Key
Timer Key
Code Change
(only in case of
malfunction)
H
INSTRUCTIONS FOR REMOVING OR REPLACING
THE FILTERS
1. METAL FILTERS
Open the panel fixed to the body of the range hood with magnets (see ill. H1). To remove
the metal grease-trapping filter (A) pull on the filter handle.
Hoods with perimeter suction:
- Open the panel (see fig. 1). Use handle A to remove the metal grease filter.
2. CARBON - ZEO FILTERS
To replace the 4 carbon-zeo filters (3 TYPE A + 1 TYPE B) mounted on the filter structure kit
KACL.930 see figure H2.
To order the new carbon zeo filters (code of the filter kit only KACL.931) refer to the dealer/
seller.
VALID ONLY FOR ITALY: Download the specific order form of the filter from www.falmec.com.
I
LIGHTING
The range hood is equipped with high efficiency, low consumption LED strips with extremely
long duration under normal use conditions. LED strip replacement must only be carried out by
qualified technicians. The LED strip is accessible by removing the VL (LG) panel as indicated
in illustration I1.
Pressing the Light key will switch the light on/off
Pressing the '-' Key will decrease motor speed. If 1° (1st) speed is in gear, pressing
the '-' key will turn off the motor
If the motor is turned off, pressing the '+' key will activate the motor at 1° (1st)
speed. If the motor is operating, pressing the '+' key will increase motor speed up
to the maximum.
If the motor is active, pressing the timer key will activate/deactivate the timer
function
Press the "Luce" (Light) key together with the "Timer" key of the remote control
until the blue LED begins to slowly flash. If the "-" key of the remote control
is pressed within 5 seconds, the new code will be generated and memorised.
Memorisation is confirmed by 3 brief flashes of the LED.
To return to the default code, apply pressure on the "-" key together with the "+"
key for over 5 seconds. Memorisation of the default code will be signalled with 3
brief flashes of the LED.
Each time that a new code is generated or that the default code is set in the
remote control, it is necessary to also carry out the previously described Remote
Binding (Light Key of the pushbutton) procedure.
ASSEMBLY AND REPLACEMENT
DESCRIPTION
23