Fault; Troubleshooting - Angelo Po 0N1FR1ID Manual De Uso

The appliance has been tested before being
put into service.
The information provided below is intended
to assist in the identifi cation and correction of
any anomalies and malfunctions which might
occur during use.
The user can solve some of these problems
himself, but for others specifi c technical
knowledge or skill is required, and so they
must only be carried out by qualifi ed staff with
recognised experience acquired in the specifi c
sector of operation.

Fault

Smell of gas.
The fl ame is yellow.
The appliance does not heat
up.
The control panel does not
come on.
3269870_ut_GB_rev.2
FAULT

TROUBLESHOOTING

For all requirements contact the agents or
the headquarters of Angelo Po which can be
found in the contacts section of the website
http://www.angelopo.com.
Causes
Occasional leak because
fl ame has gone out.
Burner dirty, heat exchange
pipes clogged, condensation
drips.
Contactor not receiving
power or faulty.
Electronic circuit board not
receiving electrical power.
- 17 -
Important
Remedies
Turn off the gas supply tap and
ventilate the room.
Important Importante
Contact the after-sales service.
Check the thermostat and activate
any start-up enabling device.
Check or replace the contactor coil..
Check or swap the phase wire
connections.
GB
ENGLISH