Operation - Tripp-Lite SRCOOL12K Manual Del Propietário

Operation

Warning: Install the unit according to the instructions in the "Installation" section before attempting to operate it.
Power
Turn the unit on or off by pressing the "ON/OFF" button.
Automatic Restart Feature
The unit will turn on and resume operation automatically when power is restored after a power
outage. The unit will use the same settings that it used immediately before the power outage
occurred. Note: If the power outage is brief, the unit will run in Fan mode for two minutes
before resuming normal operation. The delay allows the compressor to depressurize so the unit
will function properly when it enters Cool mode.
Cool Mode
Pressing the "MODE" button cycles between Cool mode, Dehumidify mode and Fan mode. The
"COOL" LED illuminates when Cool mode is active.
Press the TEMP+ and TEMP- buttons to set the temperature in Cool mode. The selected
temperature is shown on the numeric display.
Press the "FAN SPEED" button to cycle between high, medium and low fan speeds. An LED
illuminates to indicate the selected fan speed.
Dehumidify Mode
Pressing the "MODE" button cycles between Cool mode, Dehumidify mode and Fan mode. The
"DRY" LED illuminates when Dehumidify mode is active. In Dehumidify mode, the fan runs
at a fixed speed and temperature controls are irrelevant. Close windows and doors for optimal
performance in Dehumidify mode.
Fan Mode
Pressing the "MODE" button cycles between Cool mode, Dehumidify mode and Fan mode. The
"FAN" LED illuminates when Fan mode is active.
Press the "FAN SPEED" button to cycle between high, medium and low fan speeds. An LED
illuminates to indicate the selected fan speed.
Timer
The "TIMER" button allows you to schedule the unit to turn on or off automatically. The
"TIMER" LED illuminates when Timer mode is active.
Timer On (Note: The unit must be off to activate the Timer On function. Confirm that mode,
temperature and fan speed settings are correct before activating the Timer On function. )
Activate the timer by pressing the "TIMER" button. Press the TEMP+ and TEMP- buttons to set
the delay (in hours) before the unit will turn on. The number of hours is shown on the numeric
display. Press the "TIMER" button again to conirm the delay.
Timer Off (Note: The unit must be on to activate the Timer Off function.)
Activate the timer by pressing the "TIMER" button. Press the TEMP+ and TEMP- buttons to set
the delay (in hours) before the unit will turn off. The number of hours is shown on the numeric
display. Press the "TIMER" button again to conirm the delay.
8
Book 1.indb 8 7/29/2011 9:35:04 AM