Periodic Maintenance - TESY ES/GCVM 50 EC Instrucciones De Uso

•
"Shower" symbol
The Shower symbol tells you that you have enough
hot water for the first shower. The quantity of water
has been calculated on the basis of average European
norms and it may not coincide with your personal
preferences for comfort.
List of errors that may be seen on the display:
Code of error Name of error
Е01 The lower sensor has been disconnected
Е02 The lower sensor is in a short circuit
Е03 The upper sensor has been disconnected
Е04 The upper sensor is in a short circuit
Note: If you see the
above listed errors, please contact an authorized
service centre. You can find a list of them in the warranty
card.
VIII.

PERIODIC MAINTENANCE

In the conditions of normal use of the water heater,
under the influence of high temperature, limestone
(the so-called lime scale) deposits on the surface of
the heating element. This worsens the heat exchange
between the heating element and the water. The
temperature on the surface of the heating element and
around it increases. Specific noise can be heard – of boiling water. The thermoregulator begins to switch on
and off more frequently. A "deceptive" activation of the
thermal protection is possible. Due to these facts, the
manufacturer recommends preventive maintenance
of your water heater every two years by an authorized
service centre or service facility, this service remaining
at the customer's expense. This preventive maintenance
should include cleaning and examination of the anode
protector (for water heaters with glass-ceramic coating),
which has to be replaced with a new one, if necessary.
To clean the appliance, use a damp cloth. Do not use
abrasive or solvent-containing detergents.
The manufacturer does not bear responsibility for
any consequences arising from non-adherence to
these instructions.
Instructions for protection of the environment
Old electric appliances contain valuable materials and
must not be disposed of with the domestic waste!
Please contribute actively for the protection of the
resources and the environment and dispose of the
appliance in the buy-back centres organized for this
purpose (if such are available).
English
symbol and any of the
Instructions for using the built-in wireless communication module (Wi-Fi)
DESCRIPTION TO ANNEX I
(1) supplier's name or trade mark; 2) model
identifier; (3) the declared load profile, expressed
by the appropriate letter and typical usage in
accordance with Table 3 of Annex VII; (4) the water
heating energy efficiency class of the model, determined
in accordance with item 1 of Annex II; (5) the water
heating energy efficiency in %, rounded to the nearest
integer; (6) the annual electricity consumption in kWh in
terms of final energy and/or the annual fuel
consumption in GJ in terms of GCV, rounded to the
nearest integer and calculated in accordance with point
4 of Annex VIII; (7) the thermostat temperature settings
of the water heater, as placed on the market; (8) daily
electricity consumption Q elec in kWh, rounded to three
decimal places; (9) the declared load profile, expressed
by the appropriate letter in accordance with Table 1 of
this Annex; (10) the quantity of mixed water at 40 °C V40
in litres, rounded to the nearest integer; (11) maximum
temperature of the thermostat; (12) 'Out of the box'
mode is the standard operating condition, setting or
mode set by the manufacturer at factory level, to be
active immediately after the appliance installation,
suitable for normal use by the end-user according to the water tapping pattern for which the product has been
designed and placed on the market; (13) the water
heating energy efficiency in %, rounded to one decimal
place; (14) All specific precautions for assembly,
installation and maintenance are described in the
operating and installation instructions. Read and follow
the operating and installation instructions. (15) All data
that is included in the product information was
determined by applying the specifications of the relevant
European directives. Differences in product information
listed elsewhere may result in different test conditions.
Only the data that is contained in this product
information is applicable and valid.
DESCRIPTION TO ANNEX II
(1) supplier's name or trade mark;
2) supplier's model identifier; (3) the energy
efficiency class, determined in accordance with item 2 of
Annex II; (4) Standing loss in W, rounded to the nearest
integer; (5) the water volume in litres, rounded to the
nearest integer; (6) Storage volume V in litres, rounded to
one decimal place; (7) Standing loss in W, rounded to
one decimal place; (8) All specific precautions for
assembly, installation and maintenance are described in
the operating and installation instructions. Read and
follow the operating and installation instructions. (9) All
data that is included in the product information was
determined by applying the specifications of the relevant
European directives. Differences in product information
listed elsewhere may result in different test conditions.
Only the data that is contained in this product
information is applicable and valid.
EN
29