Switching Off; Warnings; Safety Features; Circuit Breaker - SDMO TECHNIC 15000 TE C Manual De Utilización Y Mantenimiento

Ocultar thumbs Ver también para TECHNIC 15000 TE C:
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 25

4.3. Switching off

Stop and disconnect the equipment from the sockets (fig. A - No. 12).
Allow the engine to run on no-load for 1 or 2 minutes.
Turn the ignition key (fig. A - No. 10) to the « O » position: The generating set stops.
Shut off the fuel tap (fig. A - No. 6 & fig. C - No. 1).
Always make sure that the generating set is properly ventilated.
Even after it has stopped, the engine continues to give off heat.
Warning

5. Safety features

5.1. Circuit breaker

The set's electrical circuit is protected by one or more magnetothermal, differential or thermal cut-out switches. In the event of an
overload and/or short circuit, the supply of electrical energy may be cut.
If necessary, replace the circuit breakers in the generating set with circuit breakers with identical nominal ratings and specifications.
5.2. Oil cut-out
If there is no oil in the engine sump or if the oil pressure is low, the oil safety mechanism automatically stops the engine to prevent any
damage.
If this occurs, check the engine oil level and top it up if necessary before looking for any other cause of the problem.

6. Maintenance schedule

6.1. Reminder of use
The maintenance operations to be carried out are described in the maintenance schedule. The interval for this is supplied as a guide
and for generating sets operating with fuel and oil which conform to the specifications given in this manual.
If the generating set is used under extreme conditions, the interval between the maintenance operations must be shortened.

6.2. Maintenance table

Component
carried out when the
expiry date is reached
Screws and bolts
Engine oil
Oil filter
Fuel filter
Air filter
Starter battery
Spark plugs
Generating set
Valves*
Starter*
* Operation(s) to be entrusted to one of our dealers. ** Foam element. *** Paper element.
If used in dusty conditions, clean the air filter more frequently.

7. Maintenance procedures

Before carrying out any maintenance operation:
- switch off the generating set.
- disconnect the cap(s) of the spark plug(s) and disconnect the starter battery (if fitted).
Warning
Only use original parts or equivalent parts: risk of damage to the generating set.
Operations to be
Each time it is
Check
Check the level
Change
Replace
Replace
Check
Clean**
Replace***
Check
Check - Clean
Replace
Clean
Have checked*
Have checked*
Every
Year
used
Or
every 25 hours
•**
Every
Every
Year
Year
Or
Or
every 100
every 200
hours
hours
•***
Every
Year
Or
every 500
hours
•*
•*
Tabla de contenido
loading

Tabla de contenido