Cleaning, Maintenance And Ordering Of Spare Parts; Replacing The Cutting Line - EINHELL AGILLO Manual De Instrucciones

7. Cleaning, maintenance and
ordering of spare parts
Danger!
Before putting away or cleaning the grass trim-
mer, switch off and remove the battery pack.
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could at-
tack the plastic parts of the equipment. Ensu-
re that no water can seep into the device. The
ingress of water into an electric tool increases
the risk of an electric shock.
•
Use a brush to remove deposits from the
safety guard
7.2 Replacing the line spool
Danger! Remove the battery packs!
1. Fig. 22 Press the line spool housing together
at the points marked M and remove the spool
cover.
2. Take out the empty line spool and the pressu-
re spring.
3. Fig. 23 Thread the end of the line on the new
line spool through the eyelet (P) in the spool
cover and allow approx. 13 cm of line to pro-
ject. Insert the pressure spring (N) in the line
spool.
4. Press the spool cover back into the line spool
housing.

7.3 Replacing the cutting line

Danger! Remove the battery packs!
1. Fig. 22 Press the line spool housing together
at the points marked M and remove the spool
cover.
2. Take out the empty line spool and the pressu-
re spring.
3. Remove any remaining cutting line if there is
any.
4. Fig. 24 Insert the new cutting line through the
line mount inside the spool.
5. Wind the line with tension in a counter-clock-
wise direction.
Anl_Agillo_SPK9.indb 31 Anl_Agillo_SPK9.indb 31
GB
6. Fig. 25 Hook the line, approx. 15 cm before
the end of the line, into one of the line holders
on the edge of the spool.
7. Fig. 23 Thread the end of the line on the new
line spool through the eyelet (P) in the spool
cover. Insert the pressure spring (N) in the
line spool.
8. Pull the line sharply to release it from the line
holder.
9. Press the spool cover back into the line spool
housing.
When you start the equipment again the line will
be cut to the perfect length automatically.
Caution! Bits of the nylon line could cause
injury when fl ung out!
7.4 Sharpening the guard hood blade
The guard hood blade (Fig. 2/Item 14) can be-
come blunt over time. When you notice this, undo
the screw holding the guard hood blade on the
guard hood. Clamp the blade in a vise. Sharpen
the blade with a fl at fi le and make sure that the
angle of the cutting edge is not altered in the pro-
cess. File in one direction only.
7.5 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.6 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info
Spare line spool Art. No.: 34.050.96
Spare cutting blade Art. No.: 34.050.82
- 31 -
22.10.2018 13:45:44 22.10.2018 13:45:44