Zanussi ZRG616CW Manual De Instrucciones página 20

1. Remove the plug from
the power socket.
2. Tilt back the appliance
carefully so that the com-
pressor cannot touch the
floor.
3. Unscrew both adjustable
feet.
4. Unscrew the screws of
the door bottom hinge. Re-
move the hinge. Put over
the pin in the direction of
the arrow.
5. Unscrew and install the
screw on the opposite side.
6. Install the hinge on the
opposite side.
7. Screw both adjustable
feet.
1) If foreseen
Do a final check to make sure that:
• All screws are tightened.
• The door opens and closes correctly.
If the ambient temperature is cold (i.e. in Winter), the gas-
ket may not fit perfectly to the cabinet. In that case, wait
for the natural fitting of the gasket.
In case you do not want to carry out the above mentioned
operations, contact the nearest After Sales Service Force.
The After Sales Service specialist will carry out the rever-
sibility of the doors at your cost.
Electrical connection
Before plugging in, ensure that the voltage and frequency
shown on the rating plate correspond to your domestic
power supply.
20
8. Unscrew both screws on
the rear side.
9. Push back the top and
lift it from the fixing ele-
ments.
10. Unscrew the screws of
the door top hinge.
11. Remove the hinge. Put
over the pin in the direction
of the arrow. Install the
hinge on the opposite side.
12. Tighten the hinge.
13. Put the top in position.
14. Pull it forward.
15. Screw both screws on
the rear side.
The appliance must be earthed. The power supply cable
plug is provided with a contact for this purpose. If the do-
mestic power supply socket is not earthed, connect the
appliance to a separate earth in compliance with current
regulations, consulting a qualified electrician.
The manufacturer declines all responsibility if the above
safety precautions are not observed.
This appliance complies with the E.E.C. Directives.
16. Remove and install the
1)
handle on the opposite
side.
17. Reposition, level the
appliance, wait for at least
four hours and then con-
nect it to the power socket.