What To Do If - Zanussi ZRG616CW Manual De Instrucciones

Defrosting of the refrigerator
Frost is automatically eliminated from the evaporator of
the refrigerator compartment every time the motor com-
pressor stops, during normal use. The defrost water
drains out through a trough into a special container at the
back of the appliance, over the motor compressor, where
it evaporates.
It is important to periodically clean the defrost water drain
hole in the middle of the refrigerator compartment channel
to prevent the water overflowing and dripping onto the
food inside. Use the special cleaner provided, which you
will find already inserted into the drain hole.

What to do if...

Warning! Before troubleshooting, disconnect the
mains plug from the mains socket.
Only a qualified electrician or competent person must do
the troubleshooting that is not in this manual.
Problem
The appliance is noisy
The appliance does not operate.
The lamp does not operate.
The lamp does not work.
The compressor operates contin-
ually.
8) If foreseen.
16
Possible cause
The appliance is not supported prop-
erly
The appliance is switched off.
The mains plug is not connected to the
mains socket correctly.
The appliance has no power. There is
no voltage in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set correctly.
The door is not closed correctly.
Periods of non-operation
When the appliance is not in use for long periods, take the
following precautions:
• disconnect the appliance from electricity supply
• remove all food
• defrost
8)
and clean the appliance and all accessories
• leave the door/doors ajar to prevent unpleasant smells.
If the cabinet will be kept on, ask somebody to check it
once in a while to prevent the food inside from spoiling in
case of a power failure.
Important! There are some sounds during normal use
(compressor, refrigerant circulation).
Check if the appliance stands stable (all
the four feet should be on the floor)
Switch on the appliance.
Connect the mains plug to the mains
socket correctly.
Connect a different electrical appliance
to the mains socket.
Contact a qualified electrician.
Close and open the door.
Refer to "Replacing the lamp".
Set a higher temperature.
Refer to "Closing the door".
Solution