FLAEM ProfiNeb Manual De Instrucciones página 14

INSTRUCTIONS USE
Before each use, wash your hands accurately and clean the device as described in the paragraph
"CLEANING, SANITISATION AND DISINFECTION". The nebuliser cup and accessories are for personal
use only to avoid potential risks of transmitting infection. This device is suitable for the administra-
tion of medical substances and not, for which the administration via aerosol is foreseen; these sub-
stances are to be in any case prescribed by the Doctor. In case of too thick substances, the dilution
with a suitable physiological solution could be needed, according to the medical prescription.
During application, it is advisable to suitably protect yourself from any
dripping.
1. Insert the "L" jack (E1) of the power supply cord into socket (A5) and
then connect it to a mains outlet adequate to the device's voltage.
After using the device unplug it, the position of the socket must be
such that the device can be easily unplugged from the mains net-
work.
2. Insert the nozzle (C1.2) in the upper part (C1.3) pressing as shown
by the 2 arrows in the "Connection diagram" in point C1. Insert the
Speed selector with valve (C1.4) in the upper part (C1.3) as shown in
the "Connection diagram" in point C1.
3. Pour the medication prescribed by the doctor into the lower part (C1.1). Close the nebuliser by turning the
upper part (C1.3) clockwise.
4. Connect the accessories as indicated in the "Assembly diagram."
5. Sit comfortably holding the nebuliser in your hand, place the mouthpiece onto your mouth or alterna-
tively use the mask. Should you opt for the mask accessory, place it on your face as shown in the picture
(with or without using the elasticated strap).
6. Start the device by means of switch (A1) and breathe deeply in and out. After inhaling, we recommend
holding your breath for an instant to allow the inhaled drops of aerosol to deposit. Then exhale slowly.
7. Upon completing application, switch off the device and unplug it.
WARNING: If after the therapy session an evident deposit of moisture forms within the pipe (B), detach the
pipe from the nebuliser and dry it with the very ventilation from the compressor; this operation prevents
possible blooms of mould inside the pipe.
USE METHODS OF THE "RF7 DUAL SPEED PLUS" NEBULISER WITH SPEED SELECTION AND VALVU-
LAR SYSTEM
It is professional, quick, recommended to administer all types of medications, including the costlier ones,
even in patients with chronic diseases. Thanks to the geometry of the RF7 Dual Speed Plus
nebuliser cup internal ducts, we have obtained a recommended, active particle size to
treat even the lower respiratory tract.
For faster inhalation therapy, position the valve speed selector (C1.4) pressing on the word
MAX with your finger.
12
MAX