Pentair BLUEFURY LITE Guia De Instalacion página 7

Step 3: Connecting Hose Sections
1. After the hose sections have been cut to size, reconnect
them by pushing the hose end over the barb on the swivel.
Note: Be sure to push the hose all the way to the bottom
of the barb.
2. Move the mender nut toward the hose by turning clockwise
and rotating until tight on hose. Use pliers if needed.
Note: Be sure the same number of floats are left on hose
sections 2 and 3, as described in Step 2 on page 3.
3. To check that the hose is cut to the correct length, reconnect
the hose and wall fitting to the wall adaptor. Take the
opposite end of the hose assembly and walk to the farthest
point of the pool from the wall adaptor. The hose should
reach the edge of the pool but should not extend more
than 6 inches (15 cm) beyond the pool edge.
4. You can now connect the cleaner to the hose.
Figure 8
371885 (REV 12/2016)
WALL FITTING
FEED HOSE
(1)
FIRST
FEED HOSE (2)
SWIVEL
SECOND
SWIVEL
FARTHEST POINT OF
FROM WALL FITTING
Barb on Swivel
Feed
Hose
Connecting the Hoses to Swivels
Figure 7
LEAD
HOSE
POOL PERIMETER
Mender Nut
WATER FLOW
DIRECTION
BACK UP
VALVE
7