Layout; Items Supplied - EINHELL TH-TS 1725 U Manual De Instrucciones

Anleitung_TH_TS_1725_U_SPK8__ 24.09.12 14:53 Seite 32
GB
Ensure that you insert the batteries the right way
n
round.
Remove flat batteries immediately from the
n
equipment. There is an increased risk of leakage.
Always change all batteries in one go.
n
Insert only batteries of the same type, do not use
n
different types of batteries or used and new
batteries together.
Make sure that the equipment is switched off after
n
use.
Remove the batteries if the equipment is not used
n
over a longer period.

2. Layout

1. Saw bench
2. Saw blade guard
3. Extraction hose
4. Splitter
5. Saw blade
6. Table insert
7. Parallel stop
8. Hand wheel
9. Adjusting and locking grip
10. Base frame
11. ON/OFF switch
12. Chain bar
13. Cross stop
14. Bench width extension
15. Bench length extension
16. Extractor adapter
17. Push stick
18. Legs
19. Cross struts
20. Longitudinal struts
21. Center struts, short
22. Center struts, long
23. Rubber legs
24. Stability bar
25. Table support, short
26. Table support, long
27. Screw with wing nut
28. Oval hole in splitter
29. Countersunk head screws
30. Fixing screw
31. Eccentric lever
32. Groove
33. Knurled screw
34. Laser
35. Laser switch
36. Screws for battery compartment
37. Battery cover
38. /39. Fixing points
32

3. Items supplied

Open the packaging and take out the equipment
n
with care.
Remove the packaging material and any
n
packaging and/or transportation braces (if
available).
Check to see if all items are supplied.
n
Inspect the equipment and accessories for
n
transport damage.
If possible, please keep the packaging until the
n
end of the guarantee period.
IMPORTANT
The equipment and packaging material are not
toys. Do not let children play with plastic bags,
foils or small parts. There is a danger of
swallowing or suffocating!
Original operating instructions n
Saw table to preassembled, carbide-tipped saw
n
blade with 24 teeth
Saw blade guard
n
Extraction hose
n
Splitter with laser
n
Batteries 1.5 V AAA (2x)
n
Parallel stop
n
Stop rail
n
Cross stop
n
Table width extension (2x)
n
Table length extension
n
Push stick
n
Legs (4x)
n
Cross struts (2x)
n
Longitudinal struts (2x)
n
Center struts, short (2x)
n
Center struts, long (2x)
n
Rubber feet (4x)
n
Stability bar (2x)
n
Table support, short (4x)
n
Table support, long (2x)
n
Installation material
a) Washer M6 (52x)
b) Nut (38x)
c) Hex screw (52x)
d) Allen screw (6x)
n) Lock bolt (2x)
u) Washer M5 (6x)
v) Retaining clip
Tools
r) Open-ended wrench, size 10/13
s) Ring wrench, size 10/24
t) Allen key, size 4mm