Important Safety Instructions - Makita AN250HC Manual De Instrucciones

ENGLISH (Original instructions)
SPECIFICATIONS
Min. hose diameter
Dimensions (L X W X H)
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
IMPORTANT SAFETY
INSTRUCTIONS
WARNING: WHEN USING THIS TOOL, BASIC
SAFETY PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED TO REDUCE THE RISK OF PERSONAL
INJURY, INCLUDING THE FOLLOWING:
READ ALL INSTRUCTIONS.
1. For personal safety and proper operation and
maintenance of the tool, read this instruction
manual carefully before using the tool.
2. Always wear safety glasses to protect your
eyes from dust or pin injury. The safety
glasses should
requirements of ANSI Z87.1.
WARNING:
It is an employer's responsibility to enforce
the use of safety eye protection equipment by
the tool operators and by other persons in the
immediate working area.
3. Wear hearing protection to protect your ears
against exhaust noise and head protection.
Also wear light but not loose clothing.
Sleeves should be buttoned or rolled up. No
necktie should be worn.
4. Rushing the job or forcing the tool is
dangerous. Handle the tool carefully. Do not
operate when under the influence of alcohol,
drugs or the like.
Model
Air pressure
Nail length
Nail capacity
Net weight
conform with
295 mm (11-5/8") X 128 mm (5") X 291 mm (11-1/2")
USB097-1
5. General Tool Handling Guidelines:
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
the
6. An improperly functioning tool must not be
used.
7. Sparks sometimes fly when the tool is used.
Do not use the tool near volatile, flammable
materials such as gasoline, thinner, paint, gas,
adhesives, etc.; they will ignite and explode,
causing serious injury.
8. The area should be sufficiently illuminated to
assure safe operations. The area should be
clear and litter-free. Be especially careful to
maintain good footing and balance.
9. Only those involved in the work should be in
the vicinity. Children especially must be kept
away at all times.
10. There may be local regulations concerning
noise which must be complied with by
keeping noise levels within prescribed limits.
In certain cases, shutters should be used to
contain noise.
2
AN250HC
170 - 320 PSIG (1.18 - 2.26 MPa)
19 mm (3/4") - 25 mm (1")
Sheet-collated coil pin
100 pcs.
5 mm ( 3/16")
2.1 kg (4.7 lbs)
Always assume that the tool contains
fasteners.
Do not point the tool toward yourself or
anyone whether it contains fasteners or
not.
Do not actuate the tool unless the tool is
placed firmly against the workpiece.
Respect the tool as a working implement.
No horseplay.
Do not hold or carry the tool with a finger
on the trigger.
Do not load the tool with fasteners when
any one of the operating controls is
activated.
Do not operate the tool with any power
source other than that specified in the
tool operating/safety instructions.