Troubleshooting - Triton TQTRSS Instrucciones De Uso

Troubleshooting

Problem
No function when ON/OFF Switch (1) is operated
Slow material removal
Scratches on workpiece after sanding
Burn marks on workpiece
Excessive dust emission
EN
8
Possible Cause
No power
Defective ON/OFF Switch
Sanding sheet too fine or worn
Sanding sheet too coarse
Not enough material removed
Sanding sheet incompatible with material
Too much pressure exerted on to the sander
Dust extraction not working; sanding sheet not aligned
with dust extraction holes in the Sanding Base Plate (7);
extraction holes blocked
Dust Collection Pot (6) full
Dust Collection Pot insufficient for the task at hand
Solution
Check power supply
Have the ON/OFF Switch replaced by an authorised Triton
service centre
Fit new sanding sheet with coarser grit
Fit new sanding sheet with finer grit
Continue sanding
Fit correct sanding sheet
Use less pressure whilst moving the machine
Realign sanding sheet; unblock dust extraction holes
Empty Dust Collection Pot
Connect a vacuum dust extraction system