Tecnotest Easylight 432 M Manual Operativo página 47

ELECTRONIC HEADLIGHT CENTERING DEVICE ___________________________________________________ USE
In this case, the two arrows tell the operator that to proceed with adjustment,
it will be necessary to point the headlight upwards ( ) and towards the left
( ) using the relative adjuster screws.
The operator is thus guided through the operation without the possibility of
error.
ATTENTION:
It is advisable to first proceed with vertical adjustment. In the
example, first adjust upwards ( ) and then towards the left ( ).
Adjustment terminates when the following message appears on the display
BEAM OK followed by a ringing signal.
If required, the display indication can be compared during the operation
with the value on the optic chamber display marked with the line to which
the beam of light must correspond. Coincidence between the two lines (the
graphic one and luminous one) corresponds to the OK that appears on the
display.
• Briefly digit the SELECT/ENTER key to return to the main menu and the
TYPE OF REGULATION option. It will now be possible to proceed with
a new adjustment.
• Keep the ESC/OFF key depressed for 2 seconds to switch off the
headlight centering unit.
OPERATING INSTRUCTIONS
ELECTRONIC HEADLIGHT CENTERING DEVICE ___________________________________________________ USE
In this case, the two arrows tell the operator that to proceed with adjustment,
it will be necessary to point the headlight upwards ( ) and towards the left
( ) using the relative adjuster screws.
The operator is thus guided through the operation without the possibility of
error.
ATTENTION:
It is advisable to first proceed with vertical adjustment. In the
example, first adjust upwards ( ) and then towards the left ( ).
Adjustment terminates when the following message appears on the display
BEAM OK followed by a ringing signal.
If required, the display indication can be compared during the operation
with the value on the optic chamber display marked with the line to which
the beam of light must correspond. Coincidence between the two lines (the
graphic one and luminous one) corresponds to the OK that appears on the
display.
• Briefly digit the SELECT/ENTER key to return to the main menu and the
TYPE OF REGULATION option. It will now be possible to proceed with
a new adjustment.
• Keep the ESC/OFF key depressed for 2 seconds to switch off the
headlight centering unit.
43 OPERATING INSTRUCTIONS 43