Sony UP-21MD Manual De Instrucciones página 11

E:\3206602011_UP-21MD_Anki\3206602011\3206602011_UP21MDGB\02GB01C01-WW.fm
01GB01PL-WW.book Page 5 Wednesday, November 7, 2001 5:19 PM
When IMMED. CAP. is set to OFF:
Remote control
pulse signal
Notation Parameter MIN TYP MAX Unit Remarks
tRPE Time within 3 -
which a
remote
control
pulse should
be cleared
to zero.
tRPW Length of a 100 -
remote
control
pulse.
VRP Amplitude - -
of a remote
control
pulse.
The above example shows that the images at the seventh
and eighth positions are captured. However, images at
other positions could be captured depending on the
printer mode and printer settings.
Note
When AUTO LIVE of the FUNCTION SETUP menu is
set to OFF, the memory image is displayed on the screen
after the image is captured in memory. In such a case,
whenever you capture an image, press the SOURCE/
MEMORY button so that the source image appears on
the video monitor. Displaying the memory image does
not allow you to capture the image with the correct
timing.
When IMMED. CAP. is set to ON:
Captured image
Notation Parameter MIN TYP
12 msec - tRPE
- msec - tRPW
5 V This value VRP
is based on
the TTL
standard.
This mode is effective only when the source image is
displayed on the monitor screen. If the memory image is
displayed, the image will not be captured even if the
pulse is sent to the printer. Be sure to display the source
image when sending the pulse.
Design and specifications are subject to change without
notice.
Captured image
Remote control
pulse signal
Time within 3 -
which a
remote
control
pulse should
be cleared
to zero.
Length of a 100 -
remote
control
pulse.
Amplitude - -
of a remote
control
pulse.
Note
masterpage: Right
MAX Unit Remarks
10 msec -
- msec -
5 V This value
is based on
the TTL
standard.
5
Specifications
UP-21MD
3-206-602-01 (1)