Prior To Installation; Initial Use; Installing The Light On The Ceiling/Wall; Changing The Lamp - LIVARNO LUX 9010.006.080 Instrucciones De Montaje

Prior to installation

Important: The electrical connection must be
performed by a trained electrician or a person in-
structed in electrical installation. This person must
be familiar with the properties of the light and con-
nection regulations.
Note: Remove all packaging material before first use.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the
light itself, before you install it.
Before installation ensure that the circuit to
which the light will be connected is not ener-
gised. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 setting).
Use the voltage tester to verify it is de-ener-
gised.

Initial use

Installing the light on the
ceiling/wall
Before installation ensure that the circuit to
which the light will be connected is not ener-
gised. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 setting).
Screw the lamp shade
from the light fixture
Mount the light fixture
tion. Bear in mind the drill hole
fixture through which the power cable will
3
be inserted (see Fig. B). Mark the drill holes
with a pencil.
Drill the holes and ensure that you do not dam-
age the mains connection cable
Insert the dowels in the drilled holes. If neces-
sary, use a hammer.
Guide the house wiring
seal in the opening provided in the light fixture
. (see Fig. B).
3
Secure the house wiring cable under the cable
bridge using two screws (see Fig. C).
Note: Ensure that you insert and screw down
the individual house wiring cables according to
the colours given in the lamp terminal
counter-clockwise
2
.
3
in the desired posi-
3
in the light
9
.
6
cable through the
10
: live
8
Prior to installation / Initial use / Settings
wire: black or brown, symbol L; neutral wire,
blue, symbol N; protective earth wire:
green-yellow).
Note: The sensor ceiling light
tective insulation. The protective conductor
does not have to be connected and can re-
main loose in the sensor ceiling light
Screw the LED lamp
the light (see Fig. D)
Screw the lamp shade
light fixture (see Fig. E).
3
Replace the fuse or switch on the circuit
breaker in the fuse box (I setting).

Changing the lamp

Note: To prevent burns, only replace the lamp
when the sensor ceiling light
nected from the power supply and the lamp has
cooled down.
Disconnect the sensor ceiling light
power supply by removing the fuse to interrupt
the circuit.
Wait approx. 3 minutes until the sensor ceiling
light has cooled down.
1
Screw the lamp shade
from the light fixture
Insert the new LED lamp.
Screw the lamp shade
light fixture so that it is secure.
3
Switch the fuse back on and check that the
sensor ceiling light

Settings

You can configure sensor data for each specific
application by selecting a combination on the DIP
switch .
5
features pro-
1
.
1
into the lamp socket in
4
clockwise onto the
2
has been discon-
1
from the
1
counter-clockwise
2
.
3
clockwise onto the
2
functions.
1
GB/IE 17