Preparation; Required Tools And Materials - LIVARNO LUX 9010.006.080 Instrucciones De Montaje

Safety / Preparation
Avoid the risk of fatal injury
from electric shock
Have the electrical installation performed by
an electrician or a person trained in electrical
installation.
Always check the mains connection cable for
damage before connecting it to the mains.
Never use the light if it shows any signs of
damage.
CAUTION! A damaged mains cable poses a
danger to life due to electric shock. In the event
of damage, repairs or other problems with the
light, please contact the service centre or an
electrician.
Remove the fuse or switch off the circuit
breaker (0 setting) in the fuse box prior to
installation.
Prior to installation, verify the mains voltage on
site corresponds with the operating voltage re-
quired for the light (220–240 V∼, 50 Hz).
Never allow the light to come into contact with
water or other liquids.
Never open the housing of the light or insert
any objects into it. This will pose the risk of
fatal injury from electric shock.
Only insert insert lamps of the correct type
and do not exceed the maximum lamp output
(max. 20 W).
Broken safety glass must immedi-
ately be replaced by new safety
glass. Contact the service centre.
Only parts provided by the manufacturer may
be used.
Replace defective lamps when they have
cooled down.
Do not install the light on a wet or conductive
surface!
Prevent fire and
injury hazards
When the light is in operation, individual parts
may become hot. Allow the light to cool down
completely before performing any work.
16 GB/IE
Do not carelessly leave the light or packaging
material lying around. Plastic film/bags, plastic
parts, etc. are dangerous for children to play with.
To prevent a fire hazard do not operate the
light in its packaging.
Do not cover the light with objects. Excessive
heat build-up can result in fire.
For your safety
Install the light so that it is protected from
moisture and dirt.
Prepare the installation with care and allow
sufficient time. First organise all parts or
materials so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and always proceed with
caution.
Never install the light if you are having diffi-
culty concentrating or do not feel well.

Preparation

Required tools and materials

The tools and materials specified are not included.
This information and values specified are non-bind-
ing and are only provided as a reference. The na-
ture of the material is determined by the individual
local conditions.
– Pencil /marking tool
– Voltage tester
– Screwdriver
– Electric drill
– Drill
– Hammer
– Ladder