Preparation; Required Tools And Material; Prior To Installation; Start-Up - LIVARNO LUX 302484 Instrucciones De Montaje, De Uso Y De Seguridad

Safety / Preparation / Prior to installation / Start-up
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never install the light if you are having difficulty
concentrating or do not feel well.

Preparation

Required tools and material

The tools and materials specified are not included.
This information and these values are non-binding and
are only provided as a reference. The nature of the
material is determined by the individual local con-
ditions.
- Pencil / marking tool
- Voltage tester
- Screwdriver
- Electric drill
- Drill (ø 6 mm)
- Side cutting pliers
- Ladder

Prior to installation

Important: The electrical connection must be
performed by a qualified electrician or a person
trained in electrical installations. This person must
be familiar with the properties of the light and the
connection regulations.
Familiarise yourself with all the instructions and
diagrams in this manual, as well as with the light
itself, before you install it.
Before installation ensure that the circuit, to which
the light will be connected, is not energised. To
do so, remove the fuse or switch off the circuit
breaker in the fuse box 0 position.
Use the voltage tester to verify the de-energised
status.
26 GB/MT

Start-up

Mounting the light

Loosen the decorative nuts
Remove the silicone rings
from the screws
8
Ensure that the tooth lock washers
the screws .
8
Insert the screws
8
terminal housing
6
Place the metal support plate
screws .
8
Twist a spacer onto each screw
4
Place a silicone ring
Place the glass plate
Attach the glass plate
and a decorative nut
2
Remove the retaining
the connection housing
mounting bracket
10
Use the slotted holes for the screws
mounting bracket
10
Now drill the mounting holes (approx. 6 mm,
depth approx. 30 mm). Be sure not to damage
the supply line.
Feed the mains cable (external)
protective tube .
15
Now use the lustre terminal
connection cable for the light to the mains con-
nection cable (external)
NOTE: Be sure to correctly connect the individual
wires in the mains connection cable (external):
live wire, black or brown = symbol L, neutral
wire, blue = symbol N.
Now use the locating screws
light to the mounting bracket
Replace the fuse or switch on the circuit breaker
in the fuse box (position I).
Your light is now ready to use (Fig. C).
from the screws
1
and spacers
2
.
stay on
7
from below through the
(see Fig. A).
onto the
5
.
8
onto each spacer
2
onto the screws
3 8
with a silicone ring
3
(see Fig. A).
1
visible at the side of
11
and remove the
6
at the back.
in the
12
to mark the bores.
through the
14
to connect the
13
.
14
to connect the
11
(see Fig. B).
10
.
8
4
.
4
.