Assembly - Glomex URANIA 2 V9331 Manual Instalación Uso Y Mantenimiento

URANIA 2 V9331 - PANDORA V8001 - RHEA V8100
6.

ASSEMBLY

S
DANGER
While installing the antenna, wear the appropriate
safety equipment for the job to be carried out.
1. First of all, make sure you have chosen a cor-
rect position to install the antenna (see section
5: "Installation").
2. Remove the antenna from the packaging box.
3. Use cutting template 6.1 on page 50 and use a
felt-tip pen to mark the holes for the screws
coming out of the antenna and for and cable
passage.
Fig. 6
4. Drill the 4 holes for the passage of the 4 screws
coming out of the antenna using an electric drill
and a 8.5 mm drill tip on the supporting surface.
Fig. 7
5. Drill the hole for cable passage by means of an
electric drill and a 28 mm hollow mill.
Fig. 8
6. Position the rubber seal so that the holes
match.
46
www.glomex.it