Charger And Battery (C) - Rothenberger RO DD60 Instrucciones De Uso

Selecting gear stage (fig. B2)
Do not set the switch (3) unless the motor has stopped completely!
Setting torque limitation, drilling, impact drilling (fig. B3)
Switching on/off, setting speed (fig. A)
Switching on, speed: press the trigger (10). The speed can be changed by pressing in the trig-
ger.
Switching off: release the trigger (10). Note: The noise that the machine makes when it switches
off is due to the design (quick stop) and has no influence on the function or the service life of the
machine.
Keyless chuck (fig. B4)
With a soft tool shank, retightening may be required after a short period of operation.
Chuck with quick bit change system.
Attaching the belt hook /bit depot.
4.3 Charger and battery
Overview:
Battery pack
1
Sliding seat
2
Operation display
3
Start of operation
Before plugging in, check to see that the rated mains voltage and mains fre-
quency, as specified on the rating label, match your power supply.
Devices such as this one, which generate direct current, may have an effect on basic residual-
current circuit breakers. Use type F or better, with a release current of max. 30 mA.
Before commissioning the charger, ensure that the air slots are free. Minimum
distance to other objects is 5 cm.
Self-test:
Insert mains supply plug.
The warning display (4) and the operating indicator (3) light up one after the other for approx. 1
second and the installed fan runs for approx. 5 seconds.
Battery pack:
Charge the battery pack before use (1).
18
To remove: Push the interlock ring forward (a), advance
and pull off the chuck (b).
To mount: Push the interlock ring forward and move the
chuck as far as the limit stop on the drill spindle.
Attach the belt hook to the right (6), as shown. Attach the
bit depot to the left (5), as shown.
Warning display
4
Capacity indicator button
5
Capacity and signal indicator
6
ENGLISH
(C)