Smrt Pak Troubleshooting - Stryker SMRT 6500 Manual De Uso

SMRT PAK TROUBLESHOOTING

Note: Fully charge the SMRT Pak for two hours before troubleshooting the Pak.
Problem/Failure Recommended Action
A fully charged
SMRT Pak
does not
provide
sufficient
power for cot
operation
Charger
indicates a
SMRT Pak
error (amber
LED), but the
Pak performs
well on the cot
Charger
indicates a
temperature
delay (flashing
amber LED),
but the Pak
is within
the normal
operating
temperature
range
www.stryker.com
Troubleshooting
1. Fully charge the SMRT Pak for two hours.
A. If the charger indicator LED is solid green indicating
a fully charged and ready Pak, go to step 2.
B. If the charger indicator LED is solid amber
indicating a Pak error, replace the Pak.
2. Immediately following a full charge, remove the Pak
from the charger and check the voltage at the power
terminals on the Pak (see Figure 12 on
26 VDC minimum.
A. If the Pak has 26 VDC minimum, go to step 3.
B. If the VDC is less than 26 VDC, replace the Pak.
3. Wait exactly one hour and charge the Pak again.
A. If the charger indicator LED turns solid green
(indicating a fully charged and ready Pak) in less
than one minute, call Tech Support.
B. If the charger indicator LED flashes green for
longer than one minute, replace the Pak.
1. Fully discharge the SMRT Pak by powering a cot until
the cot indicator LED flashes red.
2. Recharge the Pak.
A. If the charger indicator LED is solid green indicating
a fully charged and ready Pak, then the Pak is
ready for use.
B. If the charger indicator LED is solid amber
indicating a Pak error, call Tech Support.
1. Remove the SMRT Pak from the charger and allow the
Pak to cool for at least four hours at room temperature.
2. Insert the Pak onto the charger.
A. If the charger indicator LED is flashing green, then
the Pak is charging.
B. If the charger indicator LED is flashing amber
indicating a temperature delay, replace the Pak.
6500-109-105 REV A
page 1-28) for
Return To Table of Contents
1-31
English