Throwing Away The Cutting Dust - Hitachi CD 7SA Manual De Instrucciones

2. Attaching the blade
CAUTION
●
After using the tipped saw blade, dust covers (A) and
(B) may become hot. Take caution when handling.
●
Do not forget to use the distance piece.
●
Before plugging in the metal cutting saw, be sure
to check to see whether the lock lever has been
returned to its original position and that the tipped
saw blade can rotate smoothly.
(1) Follow the blade removal routine in reverse.
(2) Remove any cutting dust that may have adhered
to the spindle or the washers.
(3) For mounting saw blade, the concave sides of both
washers (A) and (B) must be fitted to the saw blade
sides. Mount the saw blade on the spindle, and
finally affix washer (B) (See Fig. 9)
Carbide tipped
saw blade
Washer (B)
Bolt
Spindle
(4) Make sure that the arrow mark on the side of the
blade is aiming the direction as the direction of
arrow on the gear cover. (See Fig. 10)
Align in the direction of
the arrow
(5) Be sure to tighten the bolt sufficiently.
Washer (A)
Distance piece
Fig. 9
Fig. 10

THROWING AWAY THE CUTTING DUST

CAUTION
●
To prevent possible accidents, always turn the
metal cutting saw off and unplug before
attempting to empty out the cutting dust.
●
Cutting dust from metal materials may be very
hot. Do not touch the cutting dust or dust covers
(A) or (B) with bare hands.
●
Be careful when handling dust covers (A) and (B)
as not to bend them. If they become bent, cutting
dust may spill out.
1. Throwing away the cutting dust
If too much cutting dust accumulates inside dust
covers (A) and (B), the performance of dust collector
may decrease. Be sure to empty out the cutting dust
before the dust receptacle becomes full.
(1) 1 Hold the (resin) knob and push the latch down
to disengage the lock. (See Fig. 11 A)
2 Pull dust cover (B) back to remove. (See Fig. 11
B, C)
Latch
A
C
3 Remove dust cover (B) and throw away the
cutting dust. (See Fig. 12)
Knob
Dust cover (B)
(2) Remove any cutting dust that has adhered to dust
covers (A) and (B) and wipe them with a rag, etc.
(3) 1 Insert the dust cover (B) hook into the hole for
inserting the hook in dust cover (A). (See Fig.
13 A)
2 Push the latch down. (See Fig. 13 B)
3 Push dust cover (B) forward to replace. (See
Fig. 13 C)
After replacing the dust cover, check that the
lock is securely engaged.
English
Knob
Dust cover (B)
B
Fig. 11
Dust cover (A)
Fig. 12
11