Disposal Of The Riveting Tool - FAR KJ 70 Instrucciones De Uso

KJ 70
TOPPING UP THE OIL-DYNAMIC CIRCUIT
Verify periodically (15000 cycles), that the oil level does not go below 3/4 of the limit indicated by the proper indicator (B) .
Whether you need to top up the circuit, remove the plug (A) by means of a 17-mm wrench, then pour hydraulic oil, HLP 32 CST, until it
reaches the border of the threaded hole.
WARNING! If you fail to perform this operation, you will note power loss that will lead to jeopardise the proper working of the tool.
Therefore, you need to get rid of the air from the tool and restore the exact oil level in the oil-dynamic circuit.
Proceed as follows: put the riveting gun inside a container, in order to avoid loosing oil, and put the upper side of the booster on the same
level of the gun/and lay the feed hoses as the picture shows. Remove the oil screw cap (A) and the service plug (C) by using a 17-mm
wrench and a 5-mm allen wrench respectively. Pour oil HLP 32 CST until it flows from the hole, without plug (C), completely free from
air bubbles. When the operation has been carried out, replace the plug (C) and make sure that oil has reached the border of the threaded
hole. Screw the screw cap (A) and clean carefully the riveting tool from overflowed oil. It is very important to apply carefully to the
instructions and use always gloves when you handle the tool. Overflowed oil, during the topping, must be collected in proper containers
and delivered afterwards, to specialized waste oil getthering company. Do not smash or cut the connecting hoses between gun and booster.
WARNING! Before disconnecting the compressed air hose, make sure that it is not under pressure!
ch.17mm
A
min. 5 Nm
max. 8 Nm
WARNING: Make sure that the oil filler cap (A)
is tightened at a torque corresponding to Min.
5 Nm ÷ Max. 8 Nm.

DISPOSAL OF THE RIVETING TOOL

Follow the prescriptions of the national laws for disposing of the riveting tool.
After disconnecting the tool from the pneumatic system, disassemble and split all the components according
to the material: steel, aluminium, plastic material, etc.
Then proceed to scrap the materials in accordance with current laws.
GB
We recommend to use oil HLP 32 cSt or similars.
750305 - KJ70 – rev 13 - ( 04-2019 )
C
B
13