Filling With Water - Beper 90.521 Manual De Instrucciones

EN
Espresso machine Use instructions
4. The porta filter will then fit tightly into the machine. When fitted correctly it will be flat against the
machine with the handle perfectly centred at the front of the espresso maker.
5. Do not attempt to remove the porta filter during use.
6. Once the brewing cycle is complete, wait around 30 seconds before removing the porta filter.

FILLING WITH WATER

Fill the water container with fresh water daily. Clean the container regularly.
Ensure the water container is filled before the appliance is switched on.
To fill:
Lift the water container lid and flip it back.
Lift out the water container.
Fill the water container with cold water, ensuring the water is not filled above 'Max'.
Slide the container back into the appliance, ensuring it is pushed down until it clicks.
Close the lid on the water container.
NOTE:
Ensure the water level is monitored and refilled when necessary.
If the water container becomes empty during operation, turn the dial to O and fill the water container
with the required amount of water. As the pump may have started to take in air from the empty water
container, once
refilled it may take a few moments before the water is dispensed again.
Any deposits of dirt or lime scale may cause the valve and the seals surrounding to leak. Ensure the
seals are checked before each use, and when necessary, cleaned to remove dirt or lime deposits.
PREHEATING CUPS
Preheating the cups and the porta filter will ensure a higher coffee temperature for your enjoyment.
Plug the appliance into the mains supply and press the ON button. The blue heating light will illu-
minate.
Insert the chosen filter sieve (1 or 2 cups) into the porta filter, but do not insert any coffee into the
porta filter.
Insert the porta filter into the boiler outlet and place one or two cups underneath.
Turn the operating dial to
Once the operating temperature has been reached, the heating light will turn off and the hot water
will flow from the boiler outlet.
When the cups are 3/4 full of hot water, turn the operating dial back to neutral to switch off the pump.
Allow the cups to warm up, and then discard the water. Alternatively, place the cups on the warming
area to preheat them.
ADDING COFFEE
Ensure the coffee is ground before inserting into the porta filter.
Remove the preheated porta filter by the handle.
Add the appropriate amount of coffee using the measuring spoon.
1 cup—1 level scoop
2 cups—2 level scoops
3. Using the measuring spoon supplied, press down the coffee lightly with the tamp. Wipe away any
excess coffee from the rim of the porta filter.
17