Beper 90.521 Manual De Instrucciones página 16

Espresso machine Use instructions
Settings
The operating dial has three settings:
1. Dispenses steam or hot water through the steam nozzle.
2. O Pump is switched OFF.
3. Pump is ON; espresso is dispensed.
Once the operating dial is turned from the neutral position O, the steam nozzle or the boiler outlet will
open, steam or hot water will then be discharged. Once the dial is turned back to O, the discharge
of hot water or steam will stop.
Before using for the first time
Before using the appliance for the first time, all detachable parts must be cleaned as outlined in
the "Care and Cleaning" section. Ensure all parts are refitted before plugging the appliance into the
mains. Flush the system through with hot water as follows:
1. Fill the water container with water.
2. Place the filter sieve into the porta filter (without any ground coffee).
3. Place a suitably sized container under the boiler outlet openings.
4. Plug the appliance into the mains.
5. Set the HOT WATER/STEAM selector to the hot water position.
6. Using the ON/OFF Switch, turn the appliance on, and turn the operating dial to
Hot water will be dispensed from the outlets.
7. Leave the appliance running until half of the water from the water container has been dispensed.
8. Switch off the pump by turning the operating dial to a neutral position.
9. Empty the container and place it under the steam nozzle. Turn the operating dial to
10. Water will be dispensed through the steam nozzle as soon as the heating light goes out. Care
must be taken to avoid burning.
11. When the amount of water left in the water container has reached the 'Min' mark, switch the
pump off by turning the dial to the neutral position.
12. If the appliance has not been used for a long period of time, the same procedure should be used.
BREWING SYSTEM
The brewing system consists of the following parts:
The boiler outlet is marked with
The porta filter has 3 protrusions on the rim which help you lock the porta filter onto the boiler outlet.
INSERTING/REMOVING THE PORTA FILTER
1. Place the porta filter (which has already been filled with ground coffee) with the handle in line with
the unlock icon on the left side of the coffee spout.
2. Then push the porta filter upwards and under the machines espresso spout. To ensure it is fully
inserted, hold the porta filter in one hand and place the other hand on top of the machine.
3. Rotate the handle in an anti-clockwise direction until it is under the lock icon
espresso spout.
and symbols to support the attachment of the porta filter.
16
on the side of the