Initial Calibration; Turning Scale On/Off; Changing Units Of Measure; Menu Navigation - OHAUS Valor 2000 Serie Manual De Instrucciones

Valor 2000 Series Scales EN-5

2.5 Initial Calibration

When the scale is operated for the first time, a Span calibration is recommended to
ensure accurate weighing results. Before performing the calibration, be sure to have
the appropriate calibration weight.
Refer to section 4.2 for Span calibration procedures.
3. OPERATION

3.1 Turning Scale On/Off

To turn the scale on, press the ON/ 0/T Off button. The scale performs a display test,
momentarily displays the model/software version, and then enters the active
weighing mode.
To turn the scale off, press and hold ON/ 0/T Off button until OFF is displayed.
3.2 Zero Operation
Press the ON/ 0/T Off button to zero the weight display. The scale must be stable to
accept zero operation.
3.3 Manual Tare
Place a container on the weighing pan, then press ON/ 0/T Off. The display will
show a net value of "0". To clear the Tare value, press ON/ 0/T Off with the pan
empty.

3.4 Changing Units of Measure

Press the UNITS/Menu button to display the next available measuring unit. Only
measuring units enabled in the Unit Menu will be displayed (refer to Section 4.4).
4. SETTINGS
The Menu allows the user to customize scale settings.

4.1 Menu Navigation

Press and hold UNITS/Menu button until MENU is displayed, then release it.
Press Yes to enter the displayed menu or press No to advance to the next menu.
When viewing the menu setting, press Yes to accept the setting, or press No to
change it, then press Yes to accept the setting and move to the next menu. When
End is displayed, press Yes to exit the menu.