Battery Installation - SKF TKBA 10 Instrucciones De Uso

3. Battery installation

The TKBA 10 and 20 are powered with 2 ™ AAA LR03 alkaline batteries.
To insert the new batteries:
• Locate the "Remove to Release battery pack" sticker on the end of the
transmitter unit.
• Remove the two cross-head screws (Fig.2).
• Take out the battery pack holder by pulling on the white strip (Fig.3).
• Carefully insert two new batteries in the holder taking care to observe
polarity. Replace the battery pack holder in the unit and reit the screws.
Figure 2 Battery door
Note: Remove the batteries if the transmitter unit is to remain unused for an
extended period.
8
Figure 3 Pull on the white strip
SKF TKBA 10 & 20