Cebora JAGUAR DOUBLE PULSE SOUND MIG 2035/MD Manual De Instrucciones página 11

A
B
L
C
D
O
S
Q
E
AB
F
setting recommended by the manufacturer. Adjusting this
knob allows you to correct the arc length value. Changes
to this figure, greater than or less than the "SYNERGIC"
setting, are shown on the display G, which will show the
previous size 2 seconds after the last correction.
L - Green LED.
Indicates that continuous welding mode is activated.
M - Green LED.
Indicates that dash welding mode is activated. It lights
together with LED C.
N - Setting knob.
This knob adjusts the pause time between spot welds.
O - Key.
Pressing and releasing this key increases the numerical
value of the display Q.
When pressed together with the key R, allows selection of
the service and memory functions and saves programs.
(See chapter 6).
Pressing it for more than 2 seconds introduces the auto-
matic double pulse; this is shown by the flashing LED
H. To disable the function, hold the key down again until
the LED H stops flashing.
P- Setting knob.
In conventional programs adjustment from 1 to 10
This knob adjusts the impedance value.
For each synergic program, the optimum value is position
0. The machine automatically sets the correct impedance
G
H
I
M
N
P
R
AA
AC
Fig. 1
11