Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing or removing battery cartridge
•
Always switch off the tool before insertion or
removal of the battery cartridge.
•
To remove the battery cartridge, pull out the set
plate on the tool and grasp both sides of the car-
tridge while withdrawing it from the tool.
•
To insert the battery cartridge, align the tongue on
the battery cartridge with the groove in the housing
and slip it into place. Snap the set plate back into
place. Be sure to close the set plate fully before
using the tool to prevent the battery cartridge from
accidentally falling out of the tool.
•
Do not use force when inserting the battery car-
tridge. If the cartridge does not slide in easily, it is
not being inserted correctly.
Switch action
CAUTION:
•
Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
To prevent the switch trigger from being accidentally
pulled, a lock-off lever is provided.
To start the tool, slide the lock-off lever in the direction of
the arrow and pull the switch trigger. Release the switch
trigger to stop.
ASSEMBLY
CAUTION:
•
Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out
any work on the tool.
002481
1. Set plate
1
2. Battery car-
tridge
2
002490
1. Lock-off lever
2. Switch trigger
1
2
Installing or removing the saw blade
1
2
3
CAUTION:
•
Always clean out all chips or foreign matter adher-
ing to the blade, blade clamp and/or slider. Failure
to do so may cause insufficient tightening of the
blade, resulting in a serious injury.
To install the blade, loosen the bolt on the blade clamp
with the hex wrench. Keep the back edge of the blade
against the roller and insert the blade between the blade
clamp and the slider as far as it will go. Make sure that
you are inserting the blade into the proper position.
Fit the pin on the slider into the hole in the blade shank.
2
NOTE:
•
The hole in the blade shank will be aligned with the
pin on the slider when the blade shank hits against
the spring pin on the slider.
After the pin fits properly into the hole, tighten the bolt
clockwise securely while making sure that the blade can-
not be extracted even though you try to pull it out.
1
2
CAUTION:
•
If you tighten the bolt without the pin on the slider
fitting properly in the hole in the blade shank, the
5
002498
1. Roller
2. Blade clamp
3. Blade installing
position
002499
1. Blade clamp
1
2. Slider
3. Spring pin
3
4. Pin
4
5. Blade shank
5
6. Hole
6
002500
1. Slider
2. Hex wrench
3. Roller
3
4. Blade
4
5. Blade clamp
5
6. Shoe
6
Tabla de contenido
