Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Bevel
Angle
Type of Cut
Setting
Left side, inside corner
1. Top edge of molding against fence
33.85°
2. Miter table set right 31.62°
3. Save left end of cut
Right side, inside corner
1. Bottom edge of molding against fence
33.85°
2. Miter table set left 31.62°
3. Save left end of cut
Left side, outside corner
1. Bottom edge of molding against fence
33.85°
2. Miter table set left 31.62°
3. Save right end of cut
Right side, outside corner
1. Top edge of molding against fence
33.85°
2. Miter table set right 31.62°
3. Save right end of cut
CUTTING WARPED MATERIAL
See Figures 30 - 31.
When cutting warped material, always make sure it is
positioned on the miter table with the convex side against
the fence as shown in figure 30.
If the warped material is positioned the wrong way as
shown in figure 31, it will pinch the blade near the comple-
tion of the cut.
WARNING:
To avoid a kickback and to avoid seri-
ous personal injury, never position the concave edge
of bowed or warped material against the fence.
OPERATION
25 — English
RIGHT
WRONG
Fig. 30
Fig. 31
Tabla de contenido
