Replacing Parts; Faults, Causes And Remedies - Berkel BH+25T Manual De Uso Y Manutención

7.7 Greasing
Model ME 30 mounts an oil lubricated reduction gear transmission unit. This oil is spe-
cific for gear units and never needs to be changed. Whereas, the other models mount
grease lubricated reduction units. This type of grease never needs to be changed.
7.8 Out of service for scrapping
Most of the appliance is manufactured in stainless steel which does not require spe-
cific scrapping.
-
disconnect the on/off switch and power plug. Now dismantle the appliance
-
dismantle the electric motor and electronic and electrical components
-
dismantle the rotor and blades
All the casing and bolts are steel
7.9

Replacing parts

-
If you require spare parts contact the manufacturer. Do not use non-original parts.
We would like to remind you that these parts must be replaced and mounted by
specialised staff.
8 Faults and remedies
8.1

Faults, causes and remedies

Problems
The appliance does not
start
Cause
The on/off switch is in position 0".
The grille is raised.
The microswitch mounted on the
mixing drum does not work.
Either the electric motor or the
command circuit board is faulty.
The controls do not work or the
blades do not change direction.
22
Remedy
Switch the switch to
position "1".
Lower the grille.
Contact the aftersales
office
Contact the aftersales
office
Contact the aftersales
office.