Indicator Lamp In The Charging Station; Transportation, Storage And Disposal; How To Lift And Move The Product - Husqvarna AUTOMOWER 105 Manual De Usuario

6.1.1 Indicator lamp in the charging station

For a fully functional installation, the indicator lamp in the charging station must emit a solid or flashing green light. If
something else appears, follow the troubleshooting guide below.
There is more help on www.husqvarna.com. If you still need help, please contact your local Husqvarna
representative.
Light Cause
Green solid light
Good signals.
Green flashing light
The signals are good and
vated.
Blue flashing light
The boundary loop is not connected to the
charging station.
Break in the boundary loop.
Red flashing light Interruption in the charging station's antenna. Contact your local Husqvarna representative.
Red solid light
Fault in the circuit board or incorrect power
supply in the charging station. The fault
should be rectified by an authorized service
technician.

7 Transportation, storage and disposal

7.1 Transportation
The supplied Li-ion batteries obey the Dangerous Goods
Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package and
labels for commercial transportations, including by
third parties and forwarding agents.
• For how to remove the battery, refer to the
complete Operator's manual on
www.husqvarna.com.

7.1.1 How to lift and move the product

To safely move from or within the work area:
1. Push the STOP button to stop the product. If
security is set to the medium or high level the PIN
code has to be entered. The PIN code contains
four digits and is selected when you start the
product for the first time. Refer to complete
Operator's manual.
2. Switch off the product with the main switch or the
ON/OFF button.
20 - Transportation, storage and disposal
Action
No action required.
ECO mode is acti-
No action required.
Check that the boundary wire connectors are
fitted properly to the charging station.
Find out where the break is. Replace the
damaged section of the loop with a new loop
wire, and splice using an original coupler.
Contact your local Husqvarna representative.
105
305
3. Carry the product by the handle under the product
with the blade disc away from the body.
105
310/315/315X
420/430X/440/450X
305/310 420/430X
315/315X 440/450X
1418 - 007 - 17.09.2020